Dobinsons BU59-3518 Manual de instalación - Página 5

Navegue en línea o descargue pdf Manual de instalación para Accesorios para automóviles Dobinsons BU59-3518. Dobinsons BU59-3518 9 páginas. Bullbar for toyota landcruiser 80 series

Imprimir página

may require removing a circlip from the

fairlead and re installing once the cable is

passed through.

14. Install the roller fairlead into the bulbar.

15. Check the poly bulbar over riders, fog light

and top loop bolts are tight (Do not over

tighten the stainless steel loop mounting

bolts. Do not over tighten the poly bullbar

over riders as they will pull the over riders out

of shape).

16. With help, fit the bulbar onto the mounting

bracket and loosely fit the mounting hardware

supplied.

17. Align the bar with the vehicle into its correct

position, leaving an even gap between the top

of the bullbar wing and the bottom of the

flare of about 20mm.

18. Check for access to the clutch handle on the

winch.

19. Once you are happy with the alignment

tighten the nuts and bolts on each side.

20. Once happy with the alignment of the bullbar

drill 2 x 8mm pinning holes on each side of the

bullbar drilling through both the mounting

bracket mounting plate and bullbar mounting

plate. Fix with 8mm bolts and nyloc nuts to

keep the bullbar in its position.

21. Wire up the lights. Using a multimeter or test

light first locate the earth wire, parker positive

and indicator positive wires from the wiring

on the back of the original vehicle lights on

each side. This is easiest done by reaching in

behind the wheel arch liner and unclipping

both lights plugs for easier access.

22. Unclip the wiring from the indicator/parker

lights. Check that the wiring will be long

enough to reach the new bullbar

indicator/parker lights and extend if required.

Using the diagram at the end of this manual,

Dobinsons Springs and Suspension

join the corresponding wires to original

vehicle wires located in the previous step. The

wires can be joined by either using good

quality snap lock crimp connectors or by

soldering. Ensure the connection is secure and

is sufficiently insulated.

23. If fitting a bullbar with fog lights, the fog lights

can be connected using the original vehicle

fog light wires if fitted. If required, cut the old

fog light wiring plugs off and cut the new fog

light wiring plugs and join. If the vehicle is not

fitted with OEM fog lights the wiring loom

supplied can be used. Follow the wiring

diagram at the end of this manual.

24. Plug the wires into the indicator, parker light

plug and fog lights. Test all lights and adjust

the position of the fog lights if required

25. Fit the under bar protection kit now with the

bolts supplied. This should sit just in front of

the tow o.e. hooks.

26. Trim the wheel arch mud guard liners back so

they are not visible from the front of the

vehicle and secure.

27. Check over all items removed during

installation.

28. IMPORTANT NOTES: It is important to inform

the customer that headlight adjustment may

also be required due to the change in ride

height. It is also important to inform the

customer that there will be a change in

vehicle handling characteristics. It is also

important to note that due to their nature fog

lights are required to provide a yellow light to