fleetfinder GOLD Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para GPS fleetfinder GOLD. fleetfinder GOLD 19 páginas.

Imprimir página

8.0 ACCESSORIES

FUEL Sensor

The fleetfinder Gold system has the ability to connect to a Fuel Gauge in a

vehicle and display the output on the Online User Interface. To Connect the

Fuel sensor, please follow the instructions in the Installation Manual supplied.

NOTE: If the device was pre-ordered with no Fuel sensor included, please

contact Fleetminder staff to enable this feature on the device.

TEMP Sensor

fleetfinder Gold system can be used with an additional Temperature sensor.

The sensor has a temperature range from -25 to 105 Degrees Centigrade.

NOTE: If the device was pre-ordered with no TEMP sensor included,

please contact fleetminder staff to enable this feature on the device.

RFID Card Reader

Driver tags, or RFID cards can be used with the fleetfinder GOLD system.

The device allows up to 20 cards to be identified per device. The RFID card

can be used for simple Driver Identification, or to directly immobilise the

starter motor of a vehicle.

NOTE: To identify an RFID card on the system, please use the RFID Setup

under the Setup tab on the user interface. The immobilisation feature can be

enabled using the IMMOBILISE ON/OFF command as listed on the command

list.

Voice Kit

An optional Voice Kit can be used with the fleetfinder Gold system. The Voice

functionality is controlled by the Communications Button on the Screen.

Crash Sensor

he fleetfinder Gold system can work with an optional Crash sensor.

NOTE: If the device was pre-ordered with no crash sensor included, it

can be set up using the GREPORT command (refer command list for

full instructions)

P12

9.0 SMS SETUP

(unless preset from manufacturer)

Please make sure you have activated your SIM card before proceeding

and have disabled the message bank service. Ensure red LED indicator

is on, and the yellow light is either on or flashing. If not, then check wiring.

9.1. Register your phone as the primary identity.

- Send SMS: PIN 0000

- Wait for response

9.2. Now change your PIN.

The factory default pin (or other defined pin) as with all other

commands can only be changed from the primary identity.

To change the pin,

- Send SMS: NEWPIN 1234 ( where 1234 is your new PIN)

- Wait for response

9.3. Set secondary identity (only receives events)

(The secondary identity is used for receiving events only, not

controlling the device)

- Send SMS: PH2 +61423123456 (where +61423123456 is the

secondary contact number)

- (send PH2 without a number, to turn this feature off)

- Wait for response (primary identity)

The fleetfinder GOLD will now respond to the secondary identity as well

as the primary identity where an event has occured. These events can

include unconditional events, such as input, voltage or geofencing.

9.4. Send a map to primary phone number

- Send SMS: MAP

- Wait for response

fleetfinder Gold unit will provide a URL link. Map can be viewed

through any GPRS phone.

P13