FLEMA FPL-1.5TF Manual de inicio rápido - Página 2

Navegue en línea o descargue pdf Manual de inicio rápido para Jacks FLEMA FPL-1.5TF. FLEMA FPL-1.5TF 6 páginas. 1-1/2 ton truck transmission jack

Imprimir página
1. SAFETY
To avoid personal injury or property damage, please follow all safety
precautions. We cannot be responsible for injury or damage resulting from
unsafe and incorrect products use or system operation, or lack of
maintenance.
WARNING indicates a potential danger that requires correct action to avoid personal
injury.
IMPORTANT indicates correct action to prevent damage or equipment failure.
WARNING:
l
The hydraulic equipment operator must be a qualified operator familiar with correct
training and work experience of hydraulic equipment. Lack of knowledge in any of these
areas can lead to equipment damage or personal injury.
l
Read, understand, and follow all instructions before operating this jack.
l
Inspect the jack before each use. Do not use jack if damaged, altered, modified, leaking
hydraulic fluid or with missing or loose components.
l
To avoid personal injury, never modify or weld hydraulic equipment.
l
Never lift more that the rated capacity of the jack, overloading causes equipment failure
and possible personal injury.
l
The jack is a load lifting device, not a load holding device.
positioned, it must always be supported mechanically.
load only supported by hydraulic means.
l
Never put unbalanced or off-center loads on the jack saddle.
adapters or saddle extenders between the stock lifting saddle and the load.
incorrect loading can result in equipment failure
l
This jack was designed for lifting transmissions only. Consult the vehicle manufacturer for
the transmission's center of balance.
l
Secure the transmission to the jack's saddle with the anchorage restraint system provided
before raising or lowering the transmission.
l
Use of this product is limited to the removal, installation and transportation in the lowered
position, of transmissions, transfer cases and trans axles.
l
Always wear safety glasses and/or other protective equipment that meet or exceed ANSI
Z87.1 and OSHA standards.
l
Use the jack ONLY on hard, level surfaces capable of sustaining the load. Use on other
surface
IMPORTANT
l
Keep the jack clean at all time.
l
When the jack is not in use, release the valve and make all piston rod return to the jack.
l
Use hydraulic equipment in normal operating temperatures. Do not use equipment in
temperatures of 65 ℃ (150 ℉ ) or higher. Overheating will soften seals and weakens
hose material, resulting in oil leaking or other equipment failure.
Once the load has been
Never work under, or around a
Do not use saddle
The