Fleming Music Australia SST 15 Manual de instrucciones de montaje - Página 6
Navegue en línea o descargue pdf Manual de instrucciones de montaje para Guitarra Fleming Music Australia SST 15. Fleming Music Australia SST 15 11 páginas. Diy guitar kit
Imprimir página2. OUTPUT JACK (PART C)
The cavity for the output jack is located on the lower right hand side of the
body. The two wires or two ends of the dual core wire (depending on which
one you have) from the pickguard must be fed through the hole that is
between the pickguard cavity and the output jack cavity then they are to be
connected to the output jack. The "hot wire" which is the wire with a plastic
shield around it is to be soldered to the terminal that is for the TIP of the guitar
lead. The "ground wire" is to be soldered to the terminal that connects the
main shaft of the guitar lead. (see the provided wiring diagram).
After the soldering has been done, use the two screws that have been
provided to screw the output jack plate to the body of the guitar.
3. SPRING CLAW (PART G)
Turn the body over and attach the spring claw, connect by soldering the
spring claw to the ground wire which should be directed through hole in the
cavity so that it enters the pickup cavity.
Note: Most players prefer to leave the two screws quite loose in order to have
more relaxed spring tension-more about that later during set up. This can be
adjusted later.
5