DOD DP4 Manual de instalación

Navegue en línea o descargue pdf Manual de instalación para Cámaras de salpicadero DOD DP4. DOD DP4 2 páginas.

Installation Sample

Step 4

Firmly connect the DP4 module to the fuse adapter using the red cable and then secure the grounding cable.

Step 5

Tuck wires to desired location and plug car charger from the dash cam into the cigarette lighter socket of the DP4.

Step 6

Plug in the USB connector into the dash cam to ﬁnish the installation and allow recording to start immediately. If

dash cam is not previously installed, please refer to the user manual of your DOD dash cam model.

12-24Vdc

DP4 is a hardwire kit that directly supplies power to your DOD dash cam from vehicle battery based on remaining

voltage measurement. The power consumption will cut-oﬀ automatically if the voltage drops below 11.5V, to

reserve the minimum crank voltage allowing your vehicle to start and recharge when driven.

Fuse adapter with Fuse

Low voltage protection module

Grounding

Disclaimer

DOD Tech and its aﬃliates, successors, distributors, contractors, employees, and other representatives

(hereafter referred to as DOD Tech) shall in no way be responsible for this product's improper use and service.

Buyer should acknowledge that he/she is not relying on DOD Tech's skill or judgment as to whether the product is

suitable for the installation. BUYER HEREBY WAIVES ALL REMEDIES OR LIABILITIES, EXPRESSED OR IMPLIED,

ARISING BY LAW OR OTHERWISE (INCLUDING WITHOUT LIMITATION, FITNESS, MERCHANTABILITY,

AND CONSEQUENTIAL DAMAGES) WHETHER OR NOT OCCASIONED BY DOD TECH'S NEGLIGENCE.

DOD Tech assumes no liability regarding the improper installation or misapplication of its Products. It is the

installer's responsibility to check for proper installation and, if in doubt, contact the manufacturer. Under no

circumstance will DOD Tech be liable for any damages or expenses by reason of use or sale of this Product.

The installation of this product indicates that the BUYER has read and understands this

agreement and accepts the following terms and conditions. Do not use this product until you

have carefully read the agreement above.

Precautions

◎Make sure that the engine is not running before installation, fail to do so may cause electrical shock and or other

serious injuries.

◎Note that DOD Tech is not liable for any damage of DP4 and or the installed vehicle caused by customer error

including but not limited to modiﬁcations or incorrect installation.

◎Actual performance may vary by the status/state of the installed vehicle.

Cigarette Socket