DOD FX7 Manual del usuario - Página 13

Navegue en línea o descargue pdf Manual del usuario para Equipos de grabación DOD FX7. DOD FX7 18 páginas. Dod guitar effects processor/preamp owner's manual fx7

Imprimir página

A Word About Mono Operation

Using A Controller With The FX7

FX7 owner's manual

signal processing

Press the effect Select button to toggle the effect in and out of bypass

mode.

REMEMBER: The decimal point indicates that the value shown in

the display is not the stored value.

To bypass the selected Program:

1) Press the currently selected Program footswitch on the pedal-

board. The footswitch's Status LED flashes and the display

reads:

The Program selector footswitch toggles the FX7 in and out of bypass

mode.

The FX7 can operate in either stereo or mono. It is important to

remember that the way you connect your cables to the outputs can

affect the output mode. Here's a simple way to remember how it

works:

• If only one output cable is connected, the FX7 switches to mono

mode. Otherwise, it operates in stereo.

The FX7 is able to respond to most volume pedal outputs or 0/+5v

controller pedals to control the wah and volume effects in real time.

To set up the FX7 for this application:

1) Disconnect the power to the FX7.

2) Connect the output or the 0/+5v control output of a volume-

type controller pedal (such as the DOD FX17) to the Volume /

Wah controller input on the rear panel of the FX7.

3) Sweep the pedal through its entire range a few times to cali-

brate the pedal.

If the Wah is active in any Program, the controller becomes a wah

pedal. Otherwise, it acts as a volume control.

REMEMBER: If you want to use a controller pedal with the FX7,

make sure the pedal is connected to the FX7 before you apply

power. It is also important to note that the controller's pedal posi-

tion affects all Programs, even after you change Programs. If a

Program doesn't sound the way you saved it, check the position of

the controller pedal.