DOD VoFX Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Hardware informático DOD VoFX. DOD VoFX 16 páginas. Vocal fx processor/mic pre

SECTION 1 - GETTING STARTED

The VoFX, is designed to "Plug in and Go", so connect the included power supply and the VofX will power up and be

ready to serve. It is always a good ideas to follow some electrical safety standards, we have listed them below to keep

things running smooth.

• Always make sure you have a "clean" power source for connecting to

the VoFX. This means that the AC power line you connect to the VoFX

should be as free from voltage fluctuations and RF interference as

possible. In recording environments, "clean" power is also important in

preventing AC hum or buzz from getting to tape.

• Use a good quality spike / surge suppressor (also called a power strip).

This is an inexpensive solution to all but the most severe AC line

conditions.

• Always make sure that your audio lines are as far as possible from

power cables. This will further prevent noise, hum, and stray

magnetic fields from entering your signal path. If audio and power

lines must run close to each other, try to avoid running them parallel

to one another.

Front Panel Controls of the VoFX

This Front and Rear Panel Guide on the following pages, gives you the simple low down on the VoFX and Shows you

just what all the Buttons and Lights do.

The front panel of the VoFX is laid out in a simple and straight forward way to make

programming as easy as possible. Functions of each section are:

Signal Processing

5 6

9 10