Clinton 81350 Funcionamiento, cuidado y mantenimiento - Página 6
Navegue en línea o descargue pdf Funcionamiento, cuidado y mantenimiento para Mobiliario interior Clinton 81350. Clinton 81350 8 páginas. Shrouded power tables
Imprimir página
TROUBLE SHOOTING
ProBLeM: Table is squeaking.
SOLUTION: Raise the table all the way up. Disconnect the power cord. Remove the three screws on
each side of the top portion of the shroud. After removing the screws, gently guide the top portion of
the shroud over the bottom portion. The lubrication point at the center axle should now be accessible.
Lubricate the table at designated points using Molykote G-0052Fg grease. See drawing below for
lubrication locations. To reattach the shroud, raise the top portion by hand into position and reattach
with screws. DO NOT lower the table to reattach the shroud.
Back Rest
End Plug
Top Frame
Top Frame Axle
ProBLeM: Backrest does not function properly.
SOLUTION: If the headrest does not remain flat in
the down position, loosen nut "A" and
tighten nut "B."
If headrest does not move at all, loosen
nut "B" and tighten nut "A."
After proper function has been achieved,
tighten both nuts.
Back Rest Actuator Arm
Center Axle
Lubricate using
Molykote G-0052Fg
grease.
Base Axle
Base
Back Rest Cylinder
Motor
Slide Block, 4 total (Base and Top Frame)
Lubricate using Molykote G-0052Fg
grease, top and bottom contact points.
Foot Lift Actuator
Arm
Nut A
Nut B