Etac Molift Nomad Manual del usuario - Página 16
Navegue en línea o descargue pdf Manual del usuario para Equipamiento médico Etac Molift Nomad. Etac Molift Nomad 18 páginas.
Imprimir página
Maintenance
Cleaning
Detergents must be pH-neutral. Do not use
solvents or strong liquids - this may damage
surfaces on the lifter. For disinfection when
needed; use isopropyl alcohol. Avoid abrasive
cleaning products.
Clean surfaces with a damp cloth using an appro-
priate detergent.
Regular cleaning is recommended and should be
implemented in the suitable cleaning routines.
Monthly maintenance
• Run the lifter through the complete installation,
and check that it is running smoothly.
• Verify that the hand control contact is firmly
in place. Clean contact and hand control with
white spirit to remove grease and dirt.
• Check that the hand control cable has no dam-
age.
• Check that the lifting belt has no damage, re-
move hair, dirt and dust from opening and
check that the belt moves out and in easily
throughout the length of the belt.
• Run lifter up and down to verify that it moves
normally without any abnormal noise.
• Check that the battery and service light gives
no signal. Contact local service representative/
dealer or Etac Supply Gjøvik if the lifter does
not work properly or if the service light illumi-
nates.
Periodic inspection
Molift recommends periodic inspection of the
lifter once a year according to checklist on page
18. Periodic inspection is to be performed by au-
thorized personnel. The rail system has a separate
checklist for annually inspection.
One checklist is to be filled in and signed for each
lifter after inspection. The owner of the lifter is re-
sponsible for keeping the list for information.
Page 16 of 20
Troubleshooting
If you are not able to solve the fault or problems by
yourself using this manual, please contact your lo-
cal authorized service representative. If you don't
know whom to contact locally, please contact your
dealer or Etac Supply Gjøvik to get help.
Symptom
The lifter does
not work
Lifter moves
slowly or makes
noise
The lifter is not
charging
BM15101 Molift NOMAD English - Rev. M 23-08-2013
Possible cause/action
Battery discharged / charge
battery
Emergency stop is activated
(pushed in) / turn clockwise to
reset
The cable/contact of the hand
control has disconnected / re-
connect contact
Hand control has failed / use
operating buttons on lifter,
switch hand control or contact
local service representative
for service
Lifting belt is untight / tighten
lifting belt, raise lifter
Defective control electronics
/ contact local service repre-
sentative for service
Lifter is defective / contact lo-
cal service representative for
service
Brakes defective / contact lo-
cal service representative for
service
Emergency stop is activated /
Reset emergency stop
Plug for charger is not con-
nected to power (no light on
charging light) / Connect to
power outlet
Hand control not placed cor-
rect in charger / Check that
the hand control is placed
correct in the charger.
Connection between charg-
er and hand control, or hand
control and lifter, is bad /
Check and clean the con-
tact points on the charger and
hand control.