3M 6096 Ficha técnica - Página 4

Navegue en línea o descargue pdf Ficha técnica para Producto respiratorio 3M 6096. 3M 6096 5 páginas. Reusable half face respirator

Imprimir página

Fitting Instructions

Before assigning any respirator to be worn in a contaminated area,

we recommend that a qualitative or quantitative fit check be

performed before entering the workplace.

Fitting instructions must be followed each time the respirator is

worn.

1. Place the respirator over the mouth and nose, then pull the

harness over the crown of the head.

2. Take the bottom straps in both hands, place them at the back

of the neck and hook them together.

3. Tighten the top straps first by pulling on ends to achieve a

comfortable and secure fit.

4. Tighten bottom straps using either front or rear adjustments.

(Strap tension may be decreased by pushing out on back side

of buckles).

Materials

PART

Face Seal

Head Harness

Head Strap

Inhalation Valve

Exhalation Valve

Gasket

6000 Filter Body

6000 Filter Element

5000 / 2000 Series Filter material

Fit Check

Perform a positive and/or negative pressure fit check each time the

respirator is donned.

Positive pressure Face Fit check (all Filters except 3M™ 6035,

6038 / 2000 Series Filters).

1. Place the palm of the hand over the exhalation valve cover

and exhale gently.

2. If the respirator bulges slightly and no air leakage between the

face and the respirator is detected, a proper fit has been

achieved.

3. If air leakage is detected, reposition the respirator on the face

and/or readjust the tension of the strap to eliminate the

leakage.

4. Repeat the above face fit check.

5. If you cannot achieve a proper fit, do not enter the

contaminated area. See your supervisor.

Negative pressure face fit check (3M™ 6035, 6038 / 2000

Series Filters)

1. Push the filter cover down or press your thumbs into the

central indentation of the filters, inhale gently and hold your

breath for five or ten seconds.

2. If the respirator collapses slightly, a proper fit has been

achieved.

3. If air leakage is detected, reposition the respirator on the face

and/or readjust the tension of the straps to eliminate the

leakage.

4. Repeat the above face fit check.

5. If you cannot achieve a proper fit, do not enter the

contaminated area. See your supervisor.

MATERIAL

Thermoplastic elastomer

Polyethylene

Polyester / cotton / Polyisoprene

Polyisoprene

Silicone Rubber

Polystryrene

Activated / Treated Carbon

Polypropylene