Dodge RAM 3500 2009 Manual de consulta rápida - Página 5

Navegue en línea o descargue pdf Manual de consulta rápida para Automóvil Dodge RAM 3500 2009. Dodge RAM 3500 2009 13 páginas. Gas truck

tire pressure MOnitOring systeM (tpMs) - 2500 Only

TPMs MEssAGEs

• A Tire Pressure Monitoring Light and a "low tire" message will

display along with an audible chime if one or more of your vehicle's

four road tires are significantly under-inflated when operating in

either TPMs mode.

• It is recommended that you check the tire pressure in the morning

when the tires are cool; inflate each tire to the recommended pressure

for your vehicle. The light will turn off after your vehicle's tire pressures

are properly inflated and the pressure has been recognized. The

vehicle may need to be driven for up to 20 minutes above 15 mph

(25 km/h) before light will turn off.

• Temperature changes can affect tire pressures, causing the TPMs light

to turn on. Tire pressures will also increase as the vehicle is driven –

this is normal and you should not adjust for this increased pressure.

• Driving on under-inflated tires reduces your vehicle's fuel efficiency

and tire tread life. if your spare tire is in use on the vehicle, the

TPMs light may turn on. Refer to your Owner's Manual.

clOck setting

NON-NAviGATiON RADiO

• Press and hold the TIME button until the hours blink;

turn the TUNE/sCROLL control knob to set the hours.

• Press the TUNE/SCROLL control knob until the minutes begin to blink;

turn the TUNE/sCROLL control knob to set the minutes.

• Press the TUNE/SCROLL control knob to save the time change.

NAviGATiON RADiO

• The Navigation radio automatically updates clock time via Global

Positioning satellite (GPs).

• Press and hold the TIME button for three seconds to enter the Clock

setup screen.

• Highlight "Displayed Clock: User Defined Clock" and press ENTER.

• Highlight the "HR+" or "-" and press ENTER to adjust hours or

highlight the "MIN+" or "-" and press ENTER to adjust minutes.

• Select DONE to exit from the clock setting mode and press ENTER

to save your changes.