3M 6200 Instrucciones de uso - Página 4

Navegue en línea o descargue pdf Instrucciones de uso para Producto respiratorio 3M 6200. 3M 6200 16 páginas. Half facepiece respirator
También para 3M 6200: Ficha técnica (3 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (2 páginas), Instrucciones de uso (2 páginas)

1. If respirator becomes damaged, leave contaminated area immediately and repair or replace the respirator.

2. Replace filters in accordance with the filter Time Use Limitation. (See filter User Instructions.)

3. Replace cartridges in accordance with an established change schedule or earlier if smell, taste or irritation

from contaminants is detected.

NIOSH Cautions and Limitations

The following restrictions may apply. See NIOSH approval label.

A– Not for use in atmospheres containing less than 19.5 percent oxygen.

B– Not for use in atmospheres immediately dangerous to life or health.

C– Do not exceed maximum use concentrations established by regulatory standards.

D– Air-line respirators can be used only when the respirators are supplied with respirable air meeting the

requirements of CGA G-7.1 Grade D or higher quality.

E– Use only the pressure ranges and hose lengths specified in the User's Instructions.

G– If airflow is cut off, switch to filter and/or cartridge or canister and immediately exit to clean air.

H– Follow established cartridge and canister change schedules or observe ESLI to ensure that cartridge and

canisters are replaced before breakthrough occurs.

I– Contains electrical parts which have not been evaluated as an ignition source in flammable or explosive

atmospheres by MSHA/NIOSH.

J– Failure to properly use and maintain this product could result in injury or death.

K– The Occupational Safety and Health Administration regulations require gas-proof goggles to be worn

with this respirator when used against formaldehyde.

L– Follow the manufacturer's User's Instructions for changing cartridges, canister and/or filters.

M– All approved respirators shall be selected, fitted, used, and maintained in accordance with MSHA,

OSHA, and other applicable regulations.

N– Never substitute, modify, add, or omit parts. Use only exact replacement parts in the configuration as

specified by the manufacturer.

O– Refer to User's Instructions, and/or maintenance manuals for information on use and maintenance of

these respirators.

P– NIOSH does not evaluate respirators for use as surgical masks.

S– Special or critical User's Instructions and/or specific use limitations apply. Refer to User's Instructions

before donning.

S – Special or Critical Use Instructions

3M™ Mercury Vapor Cartridges (6009 and 60929) are equipped with passive 3M™ End of Service Life

Indicators (ESLI). The color change indicator must be readily visible when wearing the respirator without

manipulation. If you cannot readily see the ESLI, do not use. The mercury vapor cartridges must be

discarded when the ESLI changes to the discard color found on the mercury vapor cartridge label; or within

30 days of opening packaging; or when ESLI becomes dirty or damaged; or when odors of vapors or gases

become noticeable, whichever occurs first. Mercury vapor has no odor.

To assemble 3M

Dual Airline Combination Breathing Tubes with 3M

inhalation valves must be removed.

Cartridges/Filters, the facepiece