Doepke Dupline DPN 8A Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Sistemas de E/S Doepke Dupline DPN 8A. Doepke Dupline DPN 8A 8 páginas. Output board

Imprimir página
Doepke

11. Putting into Service

The circuit boards have to be operated with 24 VDC at terminals POW (24 VDC) and
BUS- (0 V). In order to avoid differences in potential, the common (O V) wire of the
voltage supply must be directly connected together with the Dupline signal con-
ductor (Dupline-) to the „BUS-" terminal. At no other point is a connection between
the two leads permissible. The internal 24 VDC voltage at the terminal DC+ of the
DNP 8A can be used as supply voltage for the loads at terminals O1..O8.
The Dupline signal must be routed to terminals DUP (Dupline+) and BUS- (Dupline-). At
no point within the system may the Dupline signal have a connection to earth potential.
The following table illustrates the connection configuration:
Terminal
O1
Output 1
O2
Output 2
O3
Output 3
O4
Output 4
BUS+
Dupline signal conductor +
(Dupline+)
POW
24 VDC operating voltage

12. Indicators

Indicator
Yellow LED
Dupline bus: Off: bus fault / On: bus OK
Green LED
Operating voltage: Off: no supply / On: operating voltage OK

13. Guarantee

All professionally installed, unaltered devices are covered by warranty during the statu-
tory guarantee period from the day of purchase by the end user. The guarantee is not ap-
plicable to damage incurred during transport or caused by short-circuit or overloading. In
the event of defects in workmanship or material, which are discovered within the guar-
antee period, the company will provide a replacement free of charge.

14. Technical Data

Dupline
Current input
Input / output channels None / 8
Outputs (DNP 8A)
Voltage drop
Breaking capacity
3931174/2009.06/E - The right to make technical changes reserved!
6
Description
Min.
Type NPN-transistors, not short-circuit-proof
Terminal
O5
Output 5
O6
Output 6
O7
Output 7
O8
Output 8
BUS-
Dupline signal conductor -
(Dupline-) and 0 VDC operating
voltage
DC+
Voltage for output load
Description
Typ.
100 µA
Description
Max.
1.2 V
200 mA