clivus multrum CM2 Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Aseos clivus multrum CM2. clivus multrum CM2 13 páginas.

2.0 INSTALLATION

This section outlines the requirements and procedures to ensure trouble free installation. Please follow the instructions exactly

and contact Clivus Multrum for any installation questions.

2.1

Drill

II.

Hole Saw 38mm & 65mm (Min. sizes)

III.

Hand Saw

IV.

Screwdriver

Tape Measure

VI.

100% Silicon Adhesive Sealant with Caulking Gun

VII.

Pencil

VIII.

Spirit Level

IX.

Spade

2.2

Additional 4" DWV PVC pipe and fittings for ventilation pipe depending on installation requirements.

II.

4" vent pipe supports and wall or roof flashing depending on installation requirements.

III.

PVC pipe glue.

IV.

Drain kit or excess fluid container if not purchased from Clivus Multrum.

2.3

The CM2 can be installed close to a wall with the vent pipe exiting directly through the rear wall (Figure 1) or

alternatively the vent pipe can be installed on the inside exiting up through the ceiling (Figure 2).

Figure 1: Ventilation pipe installed Outside.

Refer to Section 2.4 for ventilation pipe installation.

OM-CM2.201104

Figure 2: Ventilation pipe installed Inside. (SPECIAL ORDER)

12v EcoFan in

Housing

Refer to Section 2.8 for drainage installation detail.

Updated: 04/11/2018

Page 4 of 13