Dogtra EF3000 Manual del usuario - Página 13
Navegue en línea o descargue pdf Manual del usuario para Producto para el cuidado de mascotas Dogtra EF3000. Dogtra EF3000 18 páginas. Remote controlled dog training collars
También para Dogtra EF3000: Manual del producto (14 páginas)
Imprimir página
ADDITIONAL PARTS
spade will be easiest to close. Try to keep the 2 wires from touching as
much as possible as this will enhance your signal.
Note : When covering a large area, a trenching machine may be used to
cut into the ground. However, it is recommended that the wire be
placed in the trench by hand. A commercial wire-placing machine
may damage the wire.
IMPORTANT! Bury the fence wire after you have tested the system
and are sure it is working properly. Do not nick or scrape the fence
wire during installation as it may result in an intermittent signal or
no signal.
Make gradual turns at the corners with a radius of at least 3 feet. This will
provide a more consistent signal field that will avoid confusing the dog in
these areas.
IMPORTANT!
DO NOT run fence wire within 6 feet parallel to electrical, telephone,
cable TV or other buried wire.
DO NOT run fence wire of one section within 10 feet of another section
of fence wire or the signal may cancel.
DO NOT run the fence within 10 feet of a neighboring eF-3000 GOLD
system's boundary wire.
Driveways/Sidewalks
When crossing an asphalt driveway, make a 1/2-inch deep cut across the
driveway using a circular saw and masonry blade. Close the crack with
asphalt sealant after the fence wire is placed in it. If an expansion joint is
available on driveway and sidewalks, place fence wire in the joint and
close it with outdoor caulk. When crossing gravel, bury fence wire at
least 3 inches deep. PVC pipes or a garden hose can be used to protect
the wire. In water, anchor the wire with large rocks. Use PVC piping or
garden hose to protect the wire.
22
WIRE SPLICING
The wire connection must be waterproof
Do not use electrical tape, or soldered/twisted wire nuts in this type of
connection as it will cause an intermittent signal or disarm the system.
The waterproof splices included in the
designed to provide a sealed connection between the wires. The
insulation on the boundary wire should not be stripped before placing
wire into the holes. To use the waterproof splices, boundary wire is
placed into the outer holes of the splices. This should leave the center
hole empty. A pair of pliers should be used to gently press down and snap
together the top of the blue part of the splice.
Connecting the Fence Wire to the Transmitter
Splice the two ends of the twisted wire to each of the two ends of the
fence wire.
Drill a hole through the exterior wall or window/door sill or run the fence
wire through an existing utility line hole. Connect the twisted fence wire
to the transmitter, either wire to either terminal (wire ends must be
stripped 1/2 -inch). A red indicator light should appear indicating a
continuous fence wire field. If no light appears, check to make sure that
all fence wires are properly connected and that the wire is not damaged.
WIRE SPLICING
system are
23