DogWatch GroundsKeeper Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Producto para el cuidado de mascotas DogWatch GroundsKeeper. DogWatch GroundsKeeper 8 páginas.
Imprimir página
Step-by-step Instructions
• Install the GroundsKeeper and boundary wire and make sure the
receiver collar is adjusted properly.
(See the receiver Operating Instructions for 'Setting The Receiver')
• Place boundary flags on the edge of the boundary area - the
zones in which the receiver collar picks up a radio signal. Boundary
flags serve as visual clues for your pet (see Figures 4 and 5).
Figure 4
• Attach a leash to your pet's regular collar and play with him in
the safe zone for a few minutes. Holding the leash, walk to the
boundary area, shake a boundary flag in front of him, and firmly
say, "Watch out!" or "Careful!"
• Repeat the step above several times then allow him to walk just
past the boundary flags. As he passes the flags, he will receive
an audible warning and an electrical stimulation. Immediately call
out, "Watch out", and use the leash to pull your pet back from the
avoidance zone. Return him to the safe zone and play with him
for a few minutes to reinforce the idea that there is a safe zone
where he can play.
• Again, allow your pet to approach a boundary flags. If he hears
the audible warning and retreats to the safe zone, reinforce the
behavior with praise and affection. If your pet fails to stop at the
audible warning and receives an electrical stimulation, say
"Watch out" and use the leash to pull him back to the safe zone
before he crosses completely into an avoidance zone.
• Your pet will quickly learn not to go near the boundary areas. Each
time you set up a new boundary area, be sure to retrain your pet.
Figure 5