Aseptico CompriCart ADU-20B Manual de instrucciones de funcionamiento y mantenimiento - Página 6

Navegue en línea o descargue pdf Manual de instrucciones de funcionamiento y mantenimiento para Equipamiento médico Aseptico CompriCart ADU-20B. Aseptico CompriCart ADU-20B 12 páginas.
También para Aseptico CompriCart ADU-20B: Manual de instrucciones de funcionamiento y mantenimiento (8 páginas)

Imprimir página

1. Setting up the Unit

OPERATION FUNCTIONS:

1. THREE-WAY AIR/WATER SYRINGE -

Depress the right button for air operation,

and the left button for water operation.

Depressing both buttons will create a mist.

The syringe features quick-change

autoclavable tips: To remove a tip, press

on the locking collar surrounding the tip

socket and pull the used tip straight out of

the socket (see Fig.6). To insert a new tip,

press locking collar and push tip into

socket as far as it will go. Release collar

and gently tug on tip before using to

ensure that tip is securely locked into

socket.

Syringe Tip Sterilization:

1) Remove contaminated syringe tip.

2) Remove all visible signs of contamination

before autoclaving.

3) Autoclave tip at 132° C (270° F) for ten

minutes.

4) Sterilize between each patient use.

Figure 6

NOTE: Since only the tips can be

autoclaved, it is recommended that the

air/water syringe be bagged with a

disposable, single-use plastic sleeve

between each patient use.

2. HANDPIECE CONTROLS (Fig. 7) - The

Aseptico ADU-20B includes two

handpieces mounted to the front bar.

These are fully automatic. By placing a

handpiece into its proper holder, the

DEPRESS

LOCKING COLLAR

pressure is automatically shut off. When a

handpiece is removed from it's holder,

pressure is automatically opened and

ready for use with foot control.

The amount of air pressure supplied to

each handpiece may be adjusted by

turning the flow control for that handpiece

on the control block (See page 8).

Figure 7

3. WET/DRY FOOT CONTROL (Fig. 8) - The

foot control activates the handpieces and

water coolant spray.

Position the foot control on the floor. For

handpiece operation, apply foot pressure

to any part of the center disk. The

handpiece must be removed from its

holder before operation can begin.

WATER

APPLY

PRESSURE TO

ACTIVATE

HANDPIECE

Figure 8 - Foot Control

3-WAY

AIR/WATER

SYRINGE

LOWSPEED

CONTROL

HIGHSPEED CONTROL

WATER

OFF