Aseptico CompriCart ADU-20B Manual de instrucciones de funcionamiento y mantenimiento - Página 7

Navegue en línea o descargue pdf Manual de instrucciones de funcionamiento y mantenimiento para Equipamiento médico Aseptico CompriCart ADU-20B. Aseptico CompriCart ADU-20B 8 páginas.
También para Aseptico CompriCart ADU-20B: Manual de instrucciones de funcionamiento y mantenimiento (12 páginas)

Imprimir página

CLEANING:

Because of its simple design, the Aseptico ADU-20B CompriCart

II requires very little maintenance. Any maintenance that is

needed can be performed in minutes.

BLEEDING THE SYSTEM - If the unit will not be used for

an extended period of time, or the unit might be subjected to

freezing conditions, you should bleed the system.

Simply empty the contents of the water supply tank and install

the tank back onto the quick disconnect. Operate the air/water

syringe and highspeed handpiece with water coolant 'ON' until

just air comes through the water lines. Pack unit and store as

normal.

HANDPIECE FLUSH - Flush the handpieces for about 5

seconds after every patient, and about 20 seconds at the

beginning of each day.

WATER LINES - Disinfect the water lines weekly. Prepare a

1:10 bleach solution (1 part household bleach to 10 parts water).

Remove water reservoir and discard residual water. Replace

empty water supply tank and air purge all waterlines. Fill water

supply tank with bleach solution. Run bleach solution through

all lines. Allow bleach solution to stand in lines for 10 minutes.

Remove water supply tank and discard bleach. Flush water

supply tank and all lines thoroughly with clean water. Air purge

and leave lines dry until next clinical use.

GENERAL CLEANING - he cart exterior is designed to make

cleaning and the use of prophylactic barriers as easy as

possible. The external surfaces of the cart should be cleaned

using a mild solution of liquid detergent and water. Any external

surfaces of the unit that are contacted during use should

carefully be wiped down with a disinfectant at the beginning of

each day and between each patient.

As described in the vacuum section the high and low volume

vacuum systems should always be thoroughly cleaned after use.

PACKING THE UNIT FOR TRANSPORTATION - If the ADU-

20B unit is going to be transported, it is recommended that the

original or similar packing material be put into place to avoid

dents and scratches from parts inside of the box shifting.

WARRANTY:

Aseptico Inc. warrants its new products against defects in material and

workmanship under normal and proper use, care, and maintenance for

a period of two (2) years from date of original invoice. This two (2) year

warranty does NOT apply nor is it extended to products that are not

manufactured by Aseptico. These products may be covered by a separate

limited warranty provided by the particular manufacturer, and all claims

and questions regarding the same are to be directed to the particular

manufacturer.

Expendable components, such as batteries, fuses, light bulbs, and tubing

sets installed on Aseptico products are specifically excluded and have no

warranty. Consumable goods are warranted for the stated expiration date

of such goods.

Repair or replacement of any product(s) or part(s) under this warranty

does not extend the term of this warranty, and such product(s) or part(s)

shall remain covered by the unexpired portion of the warranty period, or

for ninety (90) days from the date of return to Aseptico, whichever is later.

This limited warranty applies only to the initial or first installation of the

product or part.

During the specific warranty periods set forth above, Aseptico will, at its

option, repair or replace the product(s) or particular part(s) that are found

to be defective in either material or workmanship in part or whole. Aseptico

shall be the sole arbiter of such action. In the event of alleged defect

under warranty, the purchaser is to notify Aseptico's Customer Service

department promptly. Customer Service will provide Return Material

Authorization (RMA) instructions, usually directing that the product be

returned for service, shipping prepaid by the buyer or end user, to Aseptico

or its designated and authorized warranty service center.

This warranty shall not apply to products (1) that have been subjected to

neglect, abuse, misuse, improper installation, inadequate maintenance, or

damage due to improper use of cleaning materials or chemicals, or non-

compliance with Aseptico's storage, installation, operation, maintenance

or environmental requirements; (2) that have undergone any modification

or repair not previously authorized by Aseptico in writing, or service, repair

or modification by or from any facility other than an authorized Aseptico

service center or technician, or that use non-authorized software or spare

or replacement parts; or (3) that fail due to reasonable and normal use or

wear and tear, or materials made, furnished or specified by the buyer or

end user.

Aseptico does not assume under this warranty any risks or liabilities

arising from the clinical use of its products, whether or not such use

involves coincidental utilization of products manufactured by others.

Under no circumstances will Aseptico be liable or responsible for special,

compensatory, incidental, consequential or punitive damages, lost profits,

lost sales, or loss of use or loss of business opportunity by or through the

use of the product. Aseptico's sole and maximum liability with respect to

the product, other than its obligations set forth above, shall be the total

purchase price paid for the product