Dogwidgets DW-5 Manual del usuario - Página 2
Navegue en línea o descargue pdf Manual del usuario para Producto para el cuidado de mascotas Dogwidgets DW-5. Dogwidgets DW-5 3 páginas. 5 2 dog training shock collars
Imprimir página
Operating the collar:
1) Power on the collar by holding the power button for 3 seconds and the red light of the collar will turn on. To power off
the collar, push the power button again for 3 seconds and the red light will turn off.
2) "V" button stands for vibration, "L" button stands for low shock and "H" button stands for high shock. The middle "V"
button will vibrate the 2 collars at the same time.
3) Don't let your dogs submerge the collars in the water as the collars are only water-resistant(Not waterproof).
Training tips:
1) Familiarize the collars and the remote control and check the collars if they are working properly and safely before
putting them on your dogs.
2) Always start with the vibration correction before using the shock correction. Most dogs will respond to the vibration
correction.
3) Remove the collar if you're done training your dog and power off the collar to save the battery life. For safety purposes,
don't let your dog wear the collar if you're not training your dog.
3) Always praise your dog after a punishment.
Troubleshooting the collars:
1) The collar has a built-in Lithium-Ion battery that can be charge by the wall charger or on the USB port of the computer.
If the collar won't hold a charge by the wall charger, try charging the collar on the USB port of the computer, if the collar
charges on the USB port then the wall charger needs to be replaced.
2) If the collar has power but won't respond to the remote control or would only work half the time, then the collar needs to
reset.
3) The red light of the remote will turn solid if the battery is fresh, if the red light flashes or doesn't go solid then the 9-volt
battery needs to be replaced. Also double check the battery if it's properly installed by following the diagram inside the
battery compartment.
Follow these steps on how to reset the collar:
1) To reset the collar, push the power button 3 times and the red led light of the collar will start flashing.
2) Then push and hold the "V" button of the remote for the corresponding collar right after the red led light of the collar
starts to flash and keep holding the "V" button until the collar vibrates.
3) Repeat the procedure for the 2nd collar but this time hold the other "V" button of the remote control.