Akrobat STORMER PLUS Manual de instalación y uso - Página 4

Navegue en línea o descargue pdf Manual de instalación y uso para Accesorios Akrobat STORMER PLUS. Akrobat STORMER PLUS 9 páginas. 10 ft, 12 ft, 14 ft and 480 cm

Imprimir página

Fitting the mat and installing the springs

Lay the mat flat inside the frame. Make sure the

logo is facing upwards. In order to make the

installation of the jumping mat easier, locate the

four rings in the 12, 3, 6 and 9 o'clock position

directly opposite each other and attach four

springs on these locations first. Then continue by

attaching springs to every eighth ring, followed

by every fourth and so on until all springs are

attached.

At first, it may look like the mat won't fit, it will

however stretch to the correct size when you

finish attaching all springs.

Attaching the frame pad

Lay the frame safety pad on top of the trampoline, aligning the pad section joints with the joints of the

frame and the eyelets facing up. Feed the elastic toggles through the eyelets so the loop end of the tie faces

outwards and the toggle end is on the inside.

When flipping the frame pad over, align the pad

according to where the safety net entrance will

be placed:

The opening of the net should be positioned

between two trampoline legs and the frame pad

section with the warnings print should mark this

entrance. Before attaching the elastic toggles,

make sure the pad section joint at the enclosure

pole junction part is set about 1 cm to the left of

the junction part as shown on the picture.

INSTALLATION AND USER MANUAL - STORMER PLUS

AKROBAT HINT:

Springs can be hard to attach, you will need a little force. Help

yourself by using one spring to pull another towards the frame

holes. Do not forget to wear gloves!

Important: Be sure all spring hooks

are well attached to the frame.

Finally, attach the frame pad with the elastics.

Pull the elastic band around the frame, insert

the toggle into the loop, then rotate the toggle

inwards to secure it. Repeat with all frame pad

elastics.

Important:

The frame pad must cover the

entire frame and all springs.

Installation of the safety net

First, place the enclosure pole that is attached to

the net into the junction part. on the right from

the warnings sign on the frame pad.

Then start inserting the rest of the enclosure

poles into junction parts. Make sure you place

each enclosure pole first through the loop on

the bottom net edge then into the junction part.

Insert the fiberglass rods into the flaps on the

top edge of the safety net Push all the fiber glass

rods together and connect them into a ring.

In order to fix the fiberglass rods in place, put

the velcro tape across the fiberglass and attach

it to the pole on the other side of the cap.

Now push the obtained ring into the plastic caps on the

top of each enclosure pole into the position shown on the

picture below.