CYP CH-517RXHS Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Media Converter CYP CH-517RXHS. CYP CH-517RXHS 20 páginas. Hdmi video scaler over cat5e/6/7 with lan/ir/rs232/bidirectional poe receiver
También para CYP CH-517RXHS: Manual de instrucciones (20 páginas)

Imprimir página
CYP CH-517RXHS Manual de instrucciones

6.2 Rear Panel

DC 24V
POWER
1
1
POWER LED: This LED will illuminate when the device is connected
to an active power supply.
2
DC 24V: Connect the 24 V DC power supply to the unit and plug
the adaptor into an AC outlet. Only one unit requires powering if
both the Transmitter and Receiver are both PoE compatible.
3
RS-232 OUT: Connect to the device that is to be controlled (via
D-Sub 9 pin female cable) by RS-232 commands.
4
LAN: Connect to an active network for LAN serving. When any
compatible LAN equipped receivers are connected, this allows
the network access (including internet access if available) to
be shared between any connected LAN equipped receivers.
Connect any Ethernet equipped device e.g. a Smart TV or games
console to the LAN port of a receiver for that device to share the
network/internet access.
Warning: DO NOT connect the LAN connection to the CAT5e/6/7
port. Doing so may cause a power shutdown and may damage the
device.
5
IR Blaster: Connect the supplied IR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
6
IR Extender: Connect to the supplied IR Receiver cables for IR
signal reception. Ensure that remote being used is within the direct
line-of-sight of the IR Extender.
7
CAT5e/6/7 IN: Connect to the Transmitter unit with a Single
CAT5e/6 cable for receiving all data signals.
MODE LED: This LED will illuminate when the power is connected.
LINK LED: This LED will illuminate when connected to a Transmitter
unit that is connected to a source that is outputting a signal.
RS232 OUT
2
3
LAN
IR
IR
Blaster
Extender
MODE
4
5
6
CAT5e/6 IN
LINK
7
4