Close Talk DU-111-02 Montaje

Navegue en línea o descargue pdf Montaje para Accesorios para cámaras Close Talk DU-111-02. Close Talk DU-111-02 3 páginas. Delegate unit battery

Mounting the DU-111-02 Delegate Unit Battery

Please read this instruction in full! Damages caused by improper handling of the batteries is not

covered by any warranties. Close Talk Conference System will under no circumstances assume any

responsibilities for direct or indirect damages caused by handling the system batteries.

The battery type used contains corrosive acids, do not try to open the battery

The battery is of a sealed, maintenance-free type and should not show any signs of leaking. In case

of signs of leakage (liquid in the battery compartment, whitish residues), be sure to use rubber

gloves when handling the battery. Clean the battery compartment with soap and water

A battery is a storage of energy. Even a used battery may still contain large amounts of energy, do

not short the battery terminals

The battery contains lead, a substance known to be harmful to the nature. Handle damaged batter-

ies with care

Requirements

Replacing the battery is a relatively simple operation but

should only be carried out by a qualified technician. The

required tools is a 3mm hex/allen key. With large

amounts of Delegate Unit's it will be advantageous to use

a power screw driver.

Please set up a proper workplace to avoid damaging the

Delegate Unit.

Opening the unit

Place the delegate unit upside down on a soft surface, be sure to not damage the microphone. Locate

the battery cover holding screws and use the appropriate tool to remove them together with the

locking washers. Do not loose the screws or washers.

Fig. 2: Delegate unit upside down, cover holding

screws are circled

On delegate units that are trolley charger capable, the brass threads inside for the cover screws are

live with battery power (see figure 4), do not short the battery terminals to these threads or an inter-

nal fuse may blow and require factory service!

Warning!

Fig. 3: Use the allen key tool to remove the two screws

Warning!

2014-01-10

Fig. 1: Hex/allen key 3mm

Page 1