Ashdown Geezer Buttler Pedal of Doom Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Pedal de música Ashdown Geezer Buttler Pedal of Doom. Ashdown Geezer Buttler Pedal of Doom 18 páginas.

Imprimir página

ASHDOWN ENGINEERING - PEDAL OF DOOM

REAR PANEL

DIRECT INJECT (D.I.)

A balanced D.I. Is provided on a latching XLR socket. This is Post E.Q. and effects signal. The output

signal from this XLR socket is set to a level and impedance suitable for connecting directly into

the input of a mixing desk for either Direct Injection into the PA system or for recording. This must

ONLY be used into a balanced input, it is not intended for any other type of connection.

JACK INPUT

Use this to plug your instrument cable in or plug in from another pedal output.

JACK OUTPUT

This is a jack output to your amp or another pedal on your board.

PEDAL OF DOOM

USER GUIDE

SPECIFICATIONS:

Inputs

Input

Outputs

D.I.Output

Equalisation

Bass

Lo Mid

Hi Mid

Treble

Power Supply

2.1mm Plug 9V Centre pin NEGATIVE @ 100 mA.

Best results will be obtained with a LINEAR regulated supply ( ie transformer type ),the

use of switching type adapters may lead to the introduction of unwanted noise.

IMPORTANT! Use correct POLARITY Power Supply, the use of the wrong power supply

will invalidate the warranty and repairs required due to the use of the wrong supply may

incur a charge.

Impedance - 3.9M ohms

Input impedance 100k

420 ohms balanced, Transformer isolated, optional ground lift

Passive 0-100%

USER GUIDE