CYP CH-1602RX Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Extensor CYP CH-1602RX. CYP CH-1602RX 15 páginas. Hdmi over hdbaset transmitter and receiver with optical audio return (oar)
También para CYP CH-1602RX: Manual de instrucciones (16 páginas)

Imprimir página

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Transmitter Front Panel

DC 48V POWER AUDIO IN

−

DC 48V and POWER LED: Plug the 48V DC power supply into the

unit and connect the adaptor to an AC outlet and the LED will

illuminate.

AUDIO IN L/R: Connect with audio source equipment such as PC

or CD player for audio signal sending to Receiver's AUDIO OUT L/R.

IR IN 2: Connect to the supplied IR Extender cable for IR signal

reception. Ensure that remote being used is within the direct line-

of-sight of the IR Extender.

IR OUT 1: Connect to the supplied IR Blaster Cable for IR signal

transmission. Place the IR Blaster in direct line-of-sight of the

equipment to be controlled.

USB: Connect from PC or Laptop for data transmit to or control

from the Receiver's USB slots.

RS-232 IN TX/RX: Connect to a PC or Laptop with 3-pin Relay cable

for the transmission of RS-232 commands. For receiving command

from Receiver side, the TX and Rx pin must be reversed.

UPDATE: This is reserved for firmware update use only. Switch

this deep switch to left for firmware update use, under normal

operation, leave the switch on right. Update procedure may be

done from the same USB port for both Transmitter and Receiver.

IR IN2 IR OUT1

USB

RS-232 IN

UPDATE