CYP CH-506TX Manual de instrucciones - Página 8
Navegue en línea o descargue pdf Manual de instrucciones para Extensor CYP CH-506TX. CYP CH-506TX 16 páginas. Hdmi/ir/rs-232 over single cat5e/cat6 extender
También para CYP CH-506TX: Manual de instrucciones (16 páginas), Manual de instrucciones (13 páginas), Manual de instrucciones (16 páginas), Manual de instrucciones (9 páginas)
Imprimir página
6.2 Receiver Front and Rear Panels
Front
IR1 Extender
RS232 Out
IR2 Blaster
1
2
1
RS-232 Out: Connect to the device that is to be controlled (with
the supplied 3.5mm phone jack to D-Sub 9-pin adaptor) by RS-232
commands.
2
IR1 Extender: Connect to the supplied IR extender cable for IR signal
reception. Ensure that remote being used is within the direct line-of-sight
of the IR extender.
3
IR2 Blaster: Connect to the supplied IR blaster cable for IR signal
transmission. Place the IR blaster in direct line of sight of the equipment
to be controlled.
4
HDMI Out: Connect to a HDMI equipped TV/monitor for display of the
HDMI input source signal.
5
DC 5V: Plug the 5 V DC power supply into the unit and connect the
adaptor to an AC outlet.
6
Link: The yellow LED will illuminate when both the input and output
CAT5e/6/7 signals are connected.
7
Power: This green LED will illuminate when the device is connected to a
power supply.
8
CAT5e/6 In: Connect to the transmitter unit with a Single CAT5e/6/7
cable for transmission of all data signals.
4
HDMI Out
3
4
Rear
DC 5V
Power
Link
5
6
7
CAT 5e /6 In
8
4