CYP PU-507-KIT Manual de instrucciones - Página 8
Navegue en línea o descargue pdf Manual de instrucciones para Extensor CYP PU-507-KIT. CYP PU-507-KIT 16 páginas. V1.4 hdmi over single cat5e/6 hdbaset 5play, single lan, set (up to 100m)
También para CYP PU-507-KIT: Manual de instrucciones (11 páginas)
Imprimir página
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front and Rear Panels
Front
HDMI In
1
2
1
HDMI In: Connect to HDMI source equipment such as a DVD or Blu-
ray player.
2
LAN: Connect to an internet or network connection.
3
RS-232 In: Connect to a PC or laptop with D-Sub 9 pin male cable for
the transmission of RS-232 commands.
4
Power LED: This blue LED will illuminate when the device is
connected to a power supply.
5
DC 24V: Plug the 24 V DC power supply into the unit and connect the
adaptor to an AC outlet.
6
IR 1 Blaster: Connect to the supplied IR blaster cable for IR signal
transmission. Place the IR blaster in direct line-of-sight of the
equipment to be controlled.
7
IR 2 Extender: Connect to the supplied IR receiver cables for IR signal
reception. Ensure that remote being used is within the direct line-of-
sight of the IR extender.
8
Link LED: The yellow LED will illuminate when both the input and
output signals are connected through the CAT cable. When it blinks
regularly it indicates the source is NOT sending a signal to the
transmitter but the transmitter and receiver are linked. If it blinks
irregularly it indicates an error has occurred.
9
CAT5e/6 Out: Connect to the reciever unit with a Single CAT5e/6
cable for tranmission of all data signals.
8
Transmitter
RS-232 In
HDMI to CAT5e/6 with LAN/IR/RS232
3
Rear
IR1 Blaster
Power
DC 24V
IR2 Extender
4
5
6
7
8
9