ASHE VZ-70 Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Registradores de datos ASHE VZ-70. ASHE VZ-70 7 páginas. Single channel data logger with micro-sd card interface

Imprimir página
SETTINGS & CALIBRATION
The following is the sequence of settings on the Digital Indicator / Controller.
to be done using Increment (
KEY
INITIAL
PRESSED
DISPLAY
(POWER
ASHE
ON)
(POWER
iPLO
ON)
iPHi
-
000.0
PROG
dP
P
PROG
r nGL
P
PROG
r nGH
P
PROG
Zero
P
PROG
SPAn
P
PROG
SEt
P
PROG
L0G
P
PROG
CP-L
P
PROG
COPy
P
(process
PROG
value)
P
(process
value)
) and Decrement (
CONTROL SETTINGS
ALTERNATING
DISPLAY
CP-F
If Input Signal is below 3.8mA or is not connected.
/CP-P
If Input Signal is above 20 mA.
CP-F Indicates Copy FAILED
CP-P indicates Copy PASS
If sensor is connected and input is between 4-20 mA,
then display will show corresponding process value
Set the D
[Options are : 1000,100.0,10.00, 1.000]
100.0
These numbers indicate the position of the Decimal with
respect to the Least Significant Digit (right-most digit).
e.g., 1000 indicates No Decimal Point.
R
ANGE
the process being measured may be set using
000.0
keys from -999 to 9999. Use
positon and
R
ANGE
setting for the process being measured may be set
100.0
using
select decimal positon and
150
Using
Using
500
Output.
The S
050.0
factory preset value.
The L
10
the factory preset value.It can be adjusted using
keys from 10 to 50 seconds
If "No" Selected and pressed PROG key. Display will
nO
come to Main Window
If "YEs" Selected and pressed PROG key. Instrument
YES
will copy the content of Microcontroller latest Logs and
stored it in Micro SD CARD
Display will show "COPY" message until data get copied
and then come to main window
As per connected Input Signal. In case of copy failure
CP-F
or absence of Micro SD Card. Display will toggle
between "CP-F" and Process Value
CP-P
If log is successfully Copied Display will toggle between
"CP-P" indicating Copy Pass and Process Value
This "CP-F" or CP-P Message will shown on regular
configured log interval (i.e; between 10 to 50 seconds)
) keys.
FUNCTION
P
.
ECIMAL
OSITION
L
setting: The desired Zero (lower) range for
OW
key to change the number
H
setting: The desired Span (higher) range
IGH
and
keys from -999 to 9999. Use
and
keys adjust the counts for 4 mA Output.
and
keys adjust the counts for 20 mA
"Set" is displayed alternately with the
-
ET
POINT
"LOG" is displayed alternately with
OG INTERVAL
All settings
and
key to select decimal
key to
key to change the number
and