CYP CDPS-UA1H2HS Manual de instrucciones - Página 8
Navegue en línea o descargue pdf Manual de instrucciones para Cables y conectores CYP CDPS-UA1H2HS. CYP CDPS-UA1H2HS 12 páginas. 1 by 2 hdmi 4k uhd splitter
También para CYP CDPS-UA1H2HS: Manual de instrucciones (12 páginas)
Imprimir página
6.2 Rear Panel
HDMI IN
1
1
HDMI IN: Connect this input to the HDMI or DVI output of your
source device such as a DVD player or Set-top Box with an HDMI
cable.
2
HDMI OUT 1~2: Connect to an HDMI equipped display (TV/monitor)
or HD Amplifier for simultaneous HDMI distribution.
3
EDID TV/STD: Use this switch to set HDMI EDID setting.
TV: When in 'TV' mode, the unit will read the EDID settings of the
display connected to HDMI OUT 1. If it detects a 4K2K capable
EDID setting it will transmit the signal in that format to all outputs. If
no 4K2K capable EDID setting is detected then the unit will output
the best resolution that all displays can support.
Note: When Output 1 is connected to a 4K2K display and Output 2
is connected to non-4K2K display no picture may be displayed. To
ensure proper display all screens must all be capable of displaying
the same resolution.
STD: When in 'STD' mode, the unit will use its own built-in EDID
settings. In this mode, the video output will be set to 1080p@60Hz
and the audio output at LPCM 2CH Stereo. Use this mode if there
are display problems in 'TV' Mode.
Note: The unit will retain and use the EDID settings of the last display
connected to the HDMI OUT 1 output if no display is connected to
this output even after switching EDID modes or a power cycle.
4
FIRMWARE: Manufacturer use only.
DC 5V: Plug the supplied power supply into the unit and connect
5
the adaptor to an AC outlet.
3
HDMI OUT
1
2
2
EDID
STD TV
FIRMWARE
3
4
DC 5V
5