Cypress CY3250-PLC20QFN Manual de inicio rápido - Página 2

Navegue en línea o descargue pdf Manual de inicio rápido para Microcontroladores Cypress CY3250-PLC20QFN. Cypress CY3250-PLC20QFN 2 páginas.

Imprimir página
The CY3250-PLC20QFN emulation POD is designed to work with the PSoC
Cube (In-Circuit Emulator). The ICE Cube can be purchased separately as a part of
the CY3215-DK kit available from the Cypress Online Store at www.cypress.com.
Getting Started:
1.
Solder one of the included emulation POD feet to your target board in place of
the Cypress CY8CPLC20 QFN part. Be sure to follow the soldering
instructions included with this kit as a guide.
2.
Connect the larger end of the CY3250-FLEXCABLE to the ICE Cube emulator.
Ensure that power is being supplied to the ICE Cube. Also, ensure that the ICE
Cube is connected to your host PC via a USB cable provided with the 
CY3215-DK In-Circuit Emulator Debugging Kit.
3.
Connect the smaller end of the CY3250-FLEXCABLE to the POD as shown on
the front side of this card.
4.
Secure the flex cable to the POD using the included compression plate and red
thumb screws.
5.
Connect the POD to the foot previously soldered to your target board, making
sure the pins align correctly using the pin 1 indicators on the POD and foot.
6.
Open the PSoC Designer application
CY3215-DK kit, and create a firmware project using the appropriate device.
7.
To begin debugging your firmware project, follow the instructions within the
PSoC Designer application
For more information about the CY8CPLC20 QFN device, visit us at
www.cypress.com. There you will find datasheets and application notes. For
application support, visit us at www.cypress.com/go/support.
A.
Update to the latest PSoC Designer™ including service pack releases at:
http://www.cypress.com/psocdesigner
© Cypress Semiconductor Corporation, 2009-2011. All rights reserved. Programmable
System-on-Chip™, and PSoC Designer™ are trademarks of Cypress Semiconductor
Corp. All other trademarks or registered trademarks referenced herein are the
property of their respective owners. The information contained herein is subject to
change without notice.
.
Flex cable
POD
Thumbscrews + 1
Compression Plate
A
, which is included on CD as part of the
Feet
Doc. # 001-54215 Rev. *A
®
ICE
Stabilizers