Cypress CY3633 Manual del usuario - Página 11

Navegue en línea o descargue pdf Manual del usuario para Microcontroladores Cypress CY3633. Cypress CY3633 20 páginas. Wirelessusb ls gaming dvk

Imprimir página
The PlayStation2 Game Controller is supported by the Platform Board assembly (121-07500*G)
with the PSoC™ device labeled "PS2 G" installed into socket U3. The Game Controller can be
powered with batteries or with the provided DC power supply connected to J5.
To configure the PS2 system, perform the following steps:
1. Turn the PlayStation2 console power ON and load any game.
2. Connect the PS2 Interface Cable to one of the two game controller ports on the PS2 Console.
3. Connect the other end of PS2 interface Cable to Platform Board, bridging connectors J1 and
J7. Pin1 of the cable must be connected to Pin6 of header J7 as shown inFigure 7.
4. On the Game Controller board, verify that the radio and the proper PSoC™ adapter board are
installed on the board before any power is supplied to the assembly. Verify that all eight poten-
tiometers, POT A-H, are turned fully counterclockwise.
5. If batteries are to be used as the power source for the Game Controller, then install them now.
Otherwise, plug in the DC power supply. Only one or the other can be used at a time. Ensure
pins 2 and 3 of header J2 are connected so that the batteries or external DC adapter are
selected as the power source.
6. Perform the binding procedure described in Section 2.3.
The mapping of the PS2 Game Controller joysticks, analog buttons, and digital buttons on the Plat-
form Board are shown in Figure 8. The eight potentiometers on the platform board act as analog
buttons, where clockwise rotation behaves as a depressed button, while fully counterclockwise
rotation behaves as a released button. The push-buttons that make up the Platform Board keypad
area are used for the Game Controller digital buttons as shown in the figure. The 'Mode' button will
cause the 'Right Joy button' to activate the 'R1' function in order to facilitate first person shooter
games.The 'Connect' LED flash rate will increase when in the button swap mode. 'Reset Factory'
is used to clear all of the stored auto bind parameters and should be used whenever the radio
module has been replaced. See Section 2.3 for more details. The 'Analog' button is used to switch
the game controller from an analog controller to a digital controller.
L e f t J o y
L e f t J o y
b u t t o n
Figure 8. PS2 Joysticks, Analog Buttons, and Digital Buttons
WirelessUSB™ LS Gaming DVK User's Guide Rev 1.1
L 2
R 2
S q u a r e
+
L 1
R 1
" G a m e p a d " a r e a o f P l a t f o r m B o a r d
Num
/
Lock
7
8
Up +
Up
Left
4
5
Left
Analog
1
2
Down +
Down
Left
0
Select
"Keypad" area of Platform Board
T r i a n g .
R i g h t J o y
+
R i g h t J o y
b u t t o n
X
O
-
*
Reset
Factory
9
Up +
Right
+
6
Start +
Right
Back
3
Down+
Right
.
Enter
Start
M ode
Page -7