Ashley BEC95 Manual de instalación y funcionamiento - Página 7
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Estufa de leña Ashley BEC95. Ashley BEC95 20 páginas. Wood burning circulator heater
También para Ashley BEC95: Manual de instalación y funcionamiento (20 páginas)
Imprimir página
A listed chimney cap should be installed to prevent entrance of rain and help eliminate down drafts. An unapproved chimney
cap, protector or spark arrester can become clogged when leaves or other matter. This blocks the chimney and causes smoke,
and the dangerous carbon monoxide in smoke, to spill back into your home where it can kill you.
There are basically two methods of metal prefabricated chimney installation. One method is to install the chimney in-
side the residence through the ceiling and the roof. The other method is to install an exterior chimney that runs up the
outside of the residence.
REMEMBER: Follow the chimney manufacturer's installation instructions and maintain the manufacturer's specifi ed
clearance distance.
Additional chimney information is presented throughout this manual. READ IT THOROUGHLY TO BE MORE THOR-
OUGHLY INFORMED.
CONNECTION OF CHIMNEY CONNECTOR TO A MASONRY CHIMNEY THROUGH A COMBUSTIBLE WALL
PART A, FIGURE 7
(FIGURE 7 CONTINUED ON NEXT PAGE)
MINIMUM 12 IN.
TO COMBUSTIBLES
PART B
FIGURE 5 -
(FIGURE 5 CONTINUED)
EC95
MASONRY CHIMNEY
CONSTRUCTED TO
NFPA 211
MINIMUM CHIMNEY CLEARANCES FROM MASONRY TO
SHEET STEEL SUPPORTS AND COMBUSTIBLES 2 IN.
FACTORY-BUILT
CHIMNEY LENGTH
NONSOLUBLE
REFACTORY
CEMENT
CHIMNEY LENGTH
FLUSH WITH INSIDE
OF FLUE
AIR SPACE
9 IN. MINIMUM
MASONRY CHIMNEY CONSTRUCTED
TO NFPA 211
MINIMUM CHIMNEY CLEARANCE TO
BRICK AND COMBUSTIBLES IS 2 IN.
MINIMUM CLEARANCES 12
IN. OF BRICK ALL AROUND
CHIMNEY CONNECTOR TO
HEATER
FIRE CLAY LINER
(5/8" MIN. WALL THICKNESS)
MIN. 3-1/2" THICK BRICK MA-
SONRY WALL
MINIMUM CLEARANCE
9 IN. ALL AROUND
CHIMNEY CONNECTOR
TO HEATER
USE CHIMNEY MFRS. PARTS TO AT-
TACH CONNECTOR SECURELY
SOLID INSULATED, LISTED
FACTORY-BUILT CHIMNEY LENGTH
SHEET STEEL SUPPORTS
(24 GAUGE MIN. THICKNESS)
7