Cypress WirelessUSB N:1 DVK Manual de inicio rápido - Página 2

Navegue en línea o descargue pdf Manual de inicio rápido para Microcontroladores Cypress WirelessUSB N:1 DVK. Cypress WirelessUSB N:1 DVK 2 páginas.

Imprimir página

3. Hardware Assembly

1. Install a WirelessUSB Radio Module into

each of the 5 Node Boards

2. For default operation, make sure the DIP

switches are all off

. Hub Setup

1. Ensure the Power Jumpers for the Hub Node

Board are in the following positions:

2. Connect the 10-pin Serial Ribbon Cable from J1 of the Serial Adapter Board to J1 of the

Hub Node Board observing pin1 polarity.

3. Connect the Serial Cable between P1 of the Serial Adapter Board and a free PC COM port.

4. Power up the Hub Node Board by plugging the 5V DC Power Adapter into J4 of the Serial

Adapter Board and into an available power outlet.

5. Press the Reset button on the Hub Node Board.

6. The Green LED (D1) should now be flashing, indicating that the Hub is operational.

Hub:

J7: position 1-2

J8: position 1-2

. Sensor Setup

1. Ensure the Power Jumpers for the 4

Sensor Node Boards are in the following

positions:

Sensor:

J7: position 2-3

J8: position 2-3

3. Press the Reset button on each Sensor Node Board.

4. The Green LED (D1) will flash every time the PSoC

wakes up to transmit a packet.

a. By default, each sensor will periodically

transmit a packet once every 5 seconds.

5. There are two ways to initiate an asynchronous packet

transfer

a. Pressing the User Button will initiate a sensor

report

b. Passing the magnet within ¾" of the Magnetic

Reed Switch will also initiate a sensor report.

4. Software Installation and Configuration

1. Insert the WirelessUSB N:1 DVK CD-ROM into your PC's CD drive and launch the CD installer:

•

D:\Install WirelessUSB N-to-1 DVK.exe

2. Follow the on-screen instructions to complete the CD installation.

3. Launch the "WirelessUSB N-to-1" software application from the desktop shortcut created by the installer.

•

The application can also be found directly on the CD at D:\Software\Nto1\Nto1\Release\Nto1.exe

4. Go to the File menu and select Preferences ->

Serial Port

2. Power up the 4 Sensor

Node Boards by

installing the AAA

batteries into the battery

holders on the back of

each sensor

5. Select the desired COM port from the pull-down

menu, select 115200 Baud, and click OK.