Ashly Protea WR-5 Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Hardware informático Ashly Protea WR-5. Ashly Protea WR-5 6 páginas. Ne product remote control
También para Ashly Protea WR-5: Nota de publicación (1 páginas), Manual de instrucciones (4 páginas)

Imprimir página

Operating Manual - WR-5 Remote Control for NE Products

Since there are many possible gain adjustment points within the various NE products, the

WR-5 displayed gain level is only a relative adjustment for that WR-5. In other words, gain could

be changed elsewhere in the host unit, independent from WR-5 control. The WR-5 can adjust gain

from a relative 0 to 99, and an upper and lower number limit can be set in the function range section

to limit the maximum and minimum reach of that control.

When a gain control button is pressed, its LED flashes and the up/down buttons determine gain.

If the up/down buttons remain idle for five seconds, the gain button becomes inactive until being

pressed again.

If a Zone Output is active for that WR-5, meaning one or more output checkboxes are selected

within the Zone Setup area, the WR-5 up/down buttons and numeric display will revert (after five

seconds of inactivity) from the individual button gain mode to the overall output gain adjust mode

for that zone. If no output is selected for that zone, the display shows "--" as the default.

5) Channel Engage/Mute - A button can be configured to engage or mute a channel or group

of channels. The button LED is on when the channel(s) are engaged on.

6) Zone Source Selection - This is used to select one or more inputs for the zone under WR-5

control. When multiple zone source select buttons are assigned uniquely different or overlapping

inputs, each button will simply add to or subtract from the other's input selections, unless the Ex-

clusive Source Selection box is checked in the zone setup, in which case only the current button's

selected inputs will be used.

The Disable Zone Level Control software checkbox allows input source selections to be

changed from the WR-5, but not the output gain. The output gain can still be adjusted from soft-

ware, but the WR-5 user is locked out from making zone output gain changes.

7) Logic Output Active High - This allows the user to toggle the Logic Output assigned pin to

the button. The LED is on when the output is High.

8) Logic Output Active Low- The LED is on when the output is Low.

9) Matrix Mixer - This is used to select one or more inputs for the zone under WR-5 control,

and allows level control of that group at the dsp matrix mixer point.