Cypress Suprex SPX-1300 Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Extensor Cypress Suprex SPX-1300. Cypress Suprex SPX-1300 16 páginas. Reader extender
También para Cypress Suprex SPX-1300: Manual de instrucciones (17 páginas)

Imprimir página

Cypress Suprex SPX-1300 Manual de instrucciones

5. To activate the relay on the Remote unit connect as shown below. These connections can be used to allow the

Remote relay to operate a DOOR STRIKE, GATE, or other locking hardware. Refer to following pages in this

document for details of each I/O operation and connection. The Relay inputs are active LOW and will activate the

relay when connected to ground."

There are two relays available for accessory outputs at the Remote end. Either relay can be used to provide the Door

Strike or Gate activation function. This example uses Relay 1.

Access Control !

Panel

LED OUT

Typical Access Control Panel Connection to activate Door Strike and reader LED.

Strike follows LED

Only Relay and LED Connections are shown for clarity, refer to previous diagrams for

Power,Data and communications connections.

Access Control !

Panel

LED OUT"

STRIKE

Typical Access Control Panel Connection to activate Door Strike and reader LED. Strike

follows separate panel output.

Suprex Operation and Initial Setup

Central Side Basic Panel Connections

2-8 to 16 VDC In"

1-Ground

8-485(+)"

7-485(-)

Central Unit

6-+5 VDC Out"

5-Prog Res 2"

4-Prog Res 1"

3-LED Input"

2-D1/Data/F2F Out "

1-D0/Clock Out"

1-D0/CLK Output

2-8 to 16 VDC In"

1-Ground

8-485(+)"

7-485(-)

Central Unit

6-+5 VDC Out"

5-Prog Res 2"

4-Prog Res 1"

3-LED Input"

2-D1/Data/F2F Out "

1-D0/Clock Out"

1-D0/CLK Output

12-RLY4 N.O."

11-RLY4 Com"

10-RLY4 N.C."

9-RLY3 N.O."

8-RLY3 Com"

7-RLY3 N.C."

6-RS232 Out"

5-RS232 In"

4-Ground"

3-Aux Out"

2-Relay2 Input"

1-Relay1 Input"