Cypress Semiconductor AutoStore STK14CA8 Hoja de especificaciones - Página 13

Navegue en línea o descargue pdf Hoja de especificaciones para Hardware informático Cypress Semiconductor AutoStore STK14CA8. Cypress Semiconductor AutoStore STK14CA8 17 páginas. 128kx8 nvsram

Imprimir página
Low Average Active Power
CMOS technology provides the STK14CA8 with the benefit of
power supply current that scales with cycle time. Less current is
drawn as the memory cycle time becomes longer than 50 ns.
Figure 16
shows
the
relationship
READ/WRITE cycle time. Worst case current consumption is
shown for commercial temperature range, V
enable at maximum frequency. Only standby current is drawn
when the chip is disabled. The overall average current drawn by
the STK14CA8 depends on the following items:
1. The duty cycle of chip enable
2. The overall cycle rate for operations
3. The ratio of READs to WRITEs
4. The operating temperature
5. The VCC Level
6. I/O Loading
Figure 16. Current vs Cycle Time
Document Number: 001-51592 Rev. **
Preventing AutoStore
The AutoStore function can be disabled by initiating an
AutoStore Disable sequence. A sequence of READ operations
is performed in a manner similar to the software STORE initi-
between
I
and
CC
ation. To initiate the AutoStore Disable sequence, the following
sequence of E controlled or G controlled READ operations must
=3.6V, and chip
CC
be performed:
Read Address
Read Address
Read Address
Read Address
Read Address
Read Address
The AutoStore can be re-enabled by initiating an AutoStore
Enable sequence. A sequence of READ operations is performed
in a manner similar to the software RECALL initiation. To initiate
the AutoStore Enable sequence, the following sequence of E
controlled or G controlled READ operations must be performed:
Read Address
Read Address
Read Address
Read Address
Read Address
Read Address
If the AutoStore function is disabled or re-enabled, a manual
STORE operation (Hardware or Software) must be issued to
save the AutoStore state through subsequent power down
cycles. The part comes from the factory with AutoStore enabled.
STK14CA8
0x4E38
Valid READ
0xB1C7
Valid READ
0x83E0
Valid READ
0x7C1F
Valid READ
0x703F
Valid READ
0x8B45
AutoStore Disable
0x4E38
Valid READ
0xB1C7
Valid READ
0x83E0
Valid READ
0x7C1F
Valid READ
0x703F
Valid READ
0x4B46
AutoStore Enable
Page 13 of 16
[+] Feedback