ACR Electronics AEROFIX 406 GPS I P-ELT - REV E Manual de soporte del producto - Página 11

Navegue en línea o descargue pdf Manual de soporte del producto para GPS ACR Electronics AEROFIX 406 GPS I P-ELT - REV E. ACR Electronics AEROFIX 406 GPS I P-ELT - REV E 17 páginas. Personal locator beacon fcc type approval is currently pending
También para ACR Electronics AEROFIX 406 GPS I P-ELT - REV E: Manual de soporte del producto (17 páginas), Manual de soporte del producto (17 páginas), Manual de soporte del producto (17 páginas), Manual de soporte del producto (17 páginas), Manual de soporte del producto (14 páginas)

To secure antenna when the holster is on your AquaFix™, be sure to deploy antenna prior to placing the holster onto

the unit. Slide the antenna through the holster to secure it to the beacon. The holster will clip together at the bottom

of holster. Rotate antenna into down position in order to wrap it around the holster to lock it in place. Make sure the

antenna runs between the two guides on the bottom of the holster. This will prevent the antenna from slipping out of

position. Finally lock the antenna into place by engaging the tab located on the antenna into the slot provided on the

To Open the Holster, squeeze inward on the two tabs located on the bottom clip and pull up on the top of the

5.3

The AquaFix™ also comes with a bulk head mounting clip that allows you to easily mount your P-

EPIRB to your console or bulk head. Simply bolt the mounting clip to your desired location and

slide the P-EPIRB onto the clip ensuring that the bottom back of the holster slides over the clip to

secure it in place (See figure 9).

Connect GPS Interface Cable

to the bulk head mount

when P-EPIRB is not attached.

Removable Holster

top right corner of the holster. Slide it in to lock in place.

holster. Rotate antenna up, and slide the holster off around the antenna.

Figure 8.

Figure 9.

Bulk Head Mount

Holster opening for the

bulk head mount.

Y1-03-0173 Rev. E