ASI EZFILL10-0390-6-1A-41 Manual de instalación y mantenimiento - Página 8

Navegue en línea o descargue pdf Manual de instalación y mantenimiento para Dispensador ASI EZFILL10-0390-6-1A-41. ASI EZFILL10-0390-6-1A-41 16 páginas. Soap dispenser

Imprimir página

INSTALLATION

Cut the 5/16" dia (Ø8) soap supply clear

tube coming from the EZFILL™ Pump-

Motor to the right length as required by

the installation.

Make sure the end of the tubes are about 1" (25)

longer than required to reach the tank bottom.

Connect the EZFill™ Pump-Motor clear

5/16" dia. (Ø8) soap supply tube to any

available locking bushing in the soap tank

cap (see 0390 OM & IG).

NOTE: The Multifeed Kit enables soap distribution for up to six (6) soap

dispensers simultaneously. When installing less than a full complement

of soap dispensers, make sure to insert and clamp the 5/16" dia x 1" long

(Ø8x25) plugs into the remaining empty holes provided.

Remove the protective sticker

covering the sensor. Keep away

from the sensor range.

Connect the Com Cable motor connector to the mating plug from

dispenser (If not already connected in Step 3 above). Please note

that since the connector is water proof, some friction will apply.

O-RING VISIBLE –

IMPROPERLY CONNECTED

Important: the 4 contacts connector should be inserted fully so that the

white O-ring is not visible and a clicking sound is heard.

NOTICE: If the 4 contacts connectors are not connected properly, the motor

will run continuously.

1408201234 Rev J

CONNECTING THE POWER SOURCE

Fill

Hose

ONLY THE GROOVES ARE VISIBLE -

CONNECTED PROPERLY

Soap Supply

Tube

05 August 2015