EG Athens 250 Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Bicicleta EG Athens 250. EG Athens 250 8 páginas.

brake. Lock in the axle by tightening the nuts on both sides with equal tightness.

9. ! WARNING: Do NOT over tighten nut against the fork; for you will risk damaging your

suspension fork.

10. Turn the bicycle back around on its wheels, and lower the kick-stand.

11. The rear LED reflector batteries are already installed, while the front LED light batteries are

supplied. Install the Front LED onto the handlebar of your bike.

12. Install the pedals to the bike. Each of the pedals has a letter indicating which side it needs to

be installed to. R=Right and L=Left. Install them using the provided wrench.

13. Install the white front reflector behind the front Fork / Suspension fork arc of your bike. Install

the front mudguard hanger onto the same screw.

14. Install the mudguard stays against the bracket provided on the fork/suspension. Place the

stays between the clip brackets and tighten the screw against the suspension fork.

15. Place the small black plastic cover over the stem screw of the bike.

16. ! WARNING: Before riding the bicycle ensure the main Li-on battery is properly installed and

locked in before riding the bicycle. If the Battery is not firmly locked onto the rear rack, it may

slide off the rack and cause damage to the battery.

17. Insert the battery into the rear rack and lock in your battery with provided key. Ensure that the

rails are properly aligned below the battery. Ensure that the battery is locked in by lightly

tugging on the battery to ensure it will not slide out.

OPERATION INSTRUCTIONS

The Electric bicycle can be operated in 3 different modes:

1. Manual Mode –

 Make sure the Battery Meter/power meter on the left of the handlebar is "OFF" and then,

pedal the bicycle normally as you would any bicycle.

2a. Pedal Assist Mode (LOW) –

 Turn on the battery power to the electric bike by switching on the Battery. Switch is on the

battery.

 Press the red "ON/OFF" button on the meter located to the left of the handlebar to turn

"ON" the system. pedal the bicycle normally as you would any bicycle.

 The motor will stop if the brake lever is depressed even if you are still peddling the bicycle.

 The motor will stop when you stop peddling in this mode.

 When first switched "ON" the motor starts off in the "LOW" power mode.

 In this mode the motor is very power efficient, and will assist you with the least power as

you pedal.

 In "LOW" mode, the system provides you with the most "miles per charge" of battery power

use among the pedal assist modes.

2b. Pedal Assist Mode (Medium) –

 To put the bike in "Medium" pedal assist mode, switch on the bike as you would on the

above "LOW" mode and then press the green "Mode" button to light up the "MED" mode

and pedal the bicycle normally as you would any bicycle.

 In this mode, the motor will assist you with a moderate amount of power as you pedal the

bicycle.

 The motor will stop if the brake lever is depressed even if you are still peddling the bicycle.