EG Geneva 500MX Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Bicicleta EG Geneva 500MX. EG Geneva 500MX 9 páginas.

4. Walk Assist Mode –

 Turn on the electrical system to the electric bike by Press the "Power" button on the

handlebar controller. And then Press and Hold the "UP" button on the handlebar controller

continuously to have the bike assist you on the road or up a hill.

 Walk assist will stop as soon as you release the "UP" button on the Handlebar Controller.

5. How to operate the Front and Rear LED Lamps -

 After turning ON the bike's system, Press the "POWER" button to engage front and rear

LED as well as the LCD back light.

 The LED lamps will cycle through 3 functions as you press and release the "POWER"

button. 1

click to turn "ON" the LED Lamps, 2

to turn "OFF" the LED Lamps. When turned in ON or Blink modes both front and rear LEDs

will behave similarly.

 The rear LED will in addition to the above modes will turn ON Solid, if you depress your

brake levers.

 ALL our electric bikes make use of a wired brake lever kill switch for safety purposes. When

the brake lever is engaged, it sends a kill signal to the controller to disable the motor under

all circumstances and condition. This will ensure the motor does not continue to spin when

you need the bicycle to stop. This bike's Rear LED lamp will also light up as long as the

brake levers are depressed.

There are 2 Battery meters on your bike. 1 is located conveniently on the Handlebar LCD. The other

Battery meter is located on the battery showing the current capacity of the battery in various states of

discharge. To check the battery capacity on the LCD simply install the battery and turn on the

electrical system. To check the battery capacity on the battery, turn on the battery and then depress

the battery meter button.

As with any Lithium-ion batteries, there are a limited number of times a battery can be charged. While

priming Lithium-ion batteries are not necessary (which means it may be charged whenever you want

without affecting its charge capacity), the number of times it is charged does affect the overall

longevity of the battery life. In addition, the Handlebar LCD display will also display the current charge

voltage of your battery.

To conserve battery power, switch OFF the electrical system by pressing and holding the "POWER"

button on the handlebar controller for 2 seconds, when the electric power is not needed.

To reset the Trip1 meter on your LCD hold the "SET" button for 2 seconds. When you see Trip1 press

"DOWN" button 2x. Press and hold "SET" button for 2 seconds to exit. The Trip2 is set to show last

operation distance and will reset 30 seconds after the the system is turned on. The ODO meter is a

total accumulation of the the display unit. "Time" refers to the total time of the current operation that

will reset when the display is turned OFF.

click to switch into Blink mode, and 3

click