EG Aircraft MX2 50CC Giant Scale Aerobatic Aircraft Manual - Página 5
Navegue en línea o descargue pdf Manual para Juguete EG Aircraft MX2 50CC Giant Scale Aerobatic Aircraft. EG Aircraft MX2 50CC Giant Scale Aerobatic Aircraft 19 páginas.
Imprimir página2. Mix up some 30 minute epoxy and coat the inside of the slots and the center of the control horns. Hint:
a scrap piece of 1/16" ply, toothpick, or old hobby blade can be used to coat the inside of the rudder slots.
Slide the control horns in place and make sure they are centered perfectly by using a ruler to measure
between the pivot holes and the hinge line. Wipe any excess glue off with isopropyl alcohol and paper
towels. Install the ball links, bolts and nuts into the holes to help assure alignment of both control horns
while the glue cures. Set aside until cured.
3. The holes for the supplied hinge points are predrilled. Locate the hinge points and dry fit the hinges
and rudder into place and test the operation. The hinges should seat fully into the holes so that the hinge
line gap is minimal while still allowing full rudder deflection.
4. Before gluing the hinges in you must first clean the hinges of any mold release agent using isopropyl
alcohol. EG also recommends scuffing up the plastic with light sandpaper for maximum glue adhesion.
5. Mix up some 30 minute epoxy and using a toothpick or small wooden dowel coat the inside of each
hinge hole with epoxy. Also put a thin layer of epoxy on one side of the hinge points. Install this end into
the holes of the rudder and make sure each hinge is properly aligned at exactly 90 degrees to the hinge
line.
6. Now coat the other end of the hinge points with epoxy and install the rudder into the trailing edge of
the vertical stabilizer. Again, make sure the hinges remain in proper alignment. Using paper towels and
some isopropyl alcohol clean off any excess epoxy from the hinges and surrounding areas.