BlueRange UN09/RED Manual del usuario - Página 2
Navegue en línea o descargue pdf Manual del usuario para Producto respiratorio BlueRange UN09/RED. BlueRange UN09/RED 16 páginas. Powered air purifying respirator papr system
Imprimir página1. INTRODUCTION
The BLUERANGE® PAPR system is an integrated face, eye and breathing protection device
designed to improve operator safety and comfort during the welding process.
The kit includes the following –
1.1
1.2
1.3
1.4
1.5
1.6
1.7
If any of the above components are not included in your pack, please contact your supplier
immediately
BEFORE WELDING
•
Check the front cover lens to make sure that they are clean and there is no dirt covering the
four sensors on the front of the filter cartridge and check the front/inside cover lens to make
sure that they are secure.
•
Check all operating parts before use for signs of wear or damage. Any scratched, cracked or
pitted parts should be replaced immediately before using again to avoid severe personal injury.
•
Check for light tightness before each use.
Select a shade number by the shade knob (see Shade Guide Table No.1) ensuring that the shade number is
the correct setting for your application. Adjust the headband so that the helmet is seated as low as possible
on the head and close to your face. The angle of the helmet is adjusted using the buckles.
DARK SHADE NUMBER SELECTION
The shades are divided to two sections, 5-8 and 9-13. The shade section is selected by switch K4. When
used for grinding, you can set the Grind/Weld switch (K5) to "GRIND". Refer to the shade guide table to
determine the proper shade number for your application. Select a shade number by the shade knob (Shade
guide Table No.1).The shade goes darker from 5 to 8 or from 9 to 13 gradually by turning knob K2.
Page 2
Auto Darkening Welding helmet
Blower master unit,
Belt with mounting plate.
Rechargeable battery.
Hose with a bayonet connector to blower unit and a bayonet connector to
mask.
Fully automatic battery charger.
Visor for grinding operation.
Auto-Darkening Filter
Welding Helmet
Auto-darkening welding helmet is designed to protect the
eyes and face from sparks, spatter, and harmful radiation
under normal welding conditions. Auto-darkening filter
automatically changes from light to dark state when the arc
is struck, and returns to the light state when welding stops.
Auto-darkening welding helmet comes ready to use. The only
thing you need to do before welding is to adjust the position
of the headband and select the correct shade number for your
application.
There is also a visor for protection on other operations.