Blueridge BM12MCC Manual de instalación - Página 11
Navegue en línea o descargue pdf Manual de instalación para Ventilador Blueridge BM12MCC. Blueridge BM12MCC 18 páginas. Ceiling cassette indoor air handler
Imprimir página
Install the indoor unit
When installing optional accessories, read
also the installation manual of the optional
accessories. Depending on the field conditions,
it may be easier to install optional accessories
before the indoor unit is installed (except for the
decoration panel). However, for existing ceiling,
install fresh air inlet component kit and branch
duct before installing the unit.
1. Install the indoor unit.
1. Attach the hanger bracket to the threaded
rod. Be sure to fix it securely by using a nut
and washer from the upper and lower sides
of the hanger bracket.
2. Securing the hanger bracket see figure
below.
Nut (field supply)
Washer
(field supply)
Revised 5/14/2020
2. Adjust the unit to the right position for
installation.
(Refer to the chapter "Preparations before
installation").
3. Check if the unit is horizontally leveled.
• Do not install the unit tilted. The indoor unit
is equipped with a built-in drain pump and
float switch. (If the unit is tilted against the
direction of the condensate flow (the drain
piping side is raised), the float switch may
malfunction and cause water to drip.)
• Check to ensure the unit is level at all four
corners.
Fig 4.5
Hanger
bracket
Double nuts
(field supply,
tighten)
Page 11