Ambi-Rad OFSU32 Instrucciones de instalación, puesta en servicio y mantenimiento - Página 4
Navegue en línea o descargue pdf Instrucciones de instalación, puesta en servicio y mantenimiento para Calentador Ambi-Rad OFSU32. Ambi-Rad OFSU32 15 páginas. Oil fired unit heaters
Imprimir páginaRead these instructions carefully, they
include important information on safety of
installation, use and maintenance.
Keep this manual safe for any further
reference.
In case the unit is sold or transferred to
another user, or in case the user should
move and leave the units, make sure that
this manual stays with the unit, so that it
can be consulted by the new user and/or
installer.
Any manufacturer's liability (under the
contract provisions or otherwise) for
damage resulting from wrong installation or
misuse, and/or non-compliance with the
instructions supplied by the manufacturer
shall be expressly excluded.
Combustion air requirements
The unit shall be installed in a suitable room
with ventilation openings in compliance
with the regulations in force, and sufficient
to obtain perfect combustion.
All oil-fired appliances require air for the
combustion process.
If sufficient amounts of combustion air are
not available, the heater or other appliance
will operate in an inefficient and unsafe
manner. Enough air must be provided to
meet the needs of all fuel-burning
appliances, as well as appliances such as
exhaust fans, which force air out of the
building. When exhaust fans, are used at
the same time as the heater, much more air
is required to ensure proper combustion and
to prevent a down-draught situation.
Insufficient air for combustion can result in
the production of carbon monoxide.
Electrical supply
The electrical installation may only be
carried out by suitably qualified persons
observing the rules in force. Qualified
personnel should check that the electric
system is adequate for the rated input
shown on the units data plate, making sure
in particular that the system wire gauge is
suitable for the rated power input of the
unit.
The units electrical safety is only achieved
when the burner is properly connected to a
safe earthing system, installed as provided
according to the safety regulations in force.
This essential safety requirement should be
2
carefully verified. In case of doubt, ask
qualified personnel to accurately inspect the
installation.
The manufacturer shall not be held liable for
damages resulting from failure to earth the
unit.
No adaptors multiple sockets and/or
extensions shall be used to connect the unit
to mains. A multi-pole switch shall be
provided to connect the units to mains, in
compliance with the safety regulations in
force.
The use of any component operating with
electric power implies that some basic rules
are observed such as the following:
• never touch the unit with wet or damp
parts of the body
• do not remove electric cables;
• do not leave the unit exposed to adverse
weather conditions (rain, sunshine etc)
unless the unit has been expressly
designed to be so exposed;
• do not allow inexperienced people to
use the unit.