d&b audiotechnik R70 Manual - Página 12
Navegue en línea o descargue pdf Manual para Equipos de grabación d&b audiotechnik R70. d&b audiotechnik R70 20 páginas. Ethernet to can interface
También para d&b audiotechnik R70: Manual rápido (2 páginas)
Imprimir páginaR70 operation and configuration
Page 12 of 20
3. R70 operation and configuration
3.1.
Note: When Power over Ethernet (PoE) is available, the external
power supply is not required.
3.2.
In order to access the d&b Remote network, the R70 interface must
have the same IP network settings as your network. Depending on the
network topology, the IP address can either be assigned manually or
automatically (DHCP).
When the R70 is connected to a network with a DHCP server present, a
matching IP address is assigned to the interface automatically.
In all other cases the R70 must be adapted manually.
The R70 IP address is set to 192.168.1.70 by factory default
(see also the label sticker on the rear panel of the R70).
3.3.
To access the R70, manually assign an IP address to the PC on your
network with the same subnet as the R70. Proceed as follows:
1.
2.
3.
4.
To display the web interface of the R70, enter the IP address of the R70
in the address bar of your web browser.
Physical setup
Ethernet
(LAN)
connection
Power
supply
IP address
Direct connection
From the "Start-Settings" menu select the "Network
Connection" associated with your network adapter.
Select "Internet Protocol (TCP/IP)" and click on "Properties".
Enter a static IP address in the same subnet as the R70 by
selecting "Use the following IP address":
IP address:
192.168.1.71
Subnet mask: 255.255.255.0
Apply the changes by clicking OK and close the network
properties dialog.
R70 Ethernet to CAN interface, Manual
d&b audiotechnik GmbH