Ambiano EA-1295 Professional Manual de instrucciones - Página 13
Navegue en línea o descargue pdf Manual de instrucciones para Electrodomésticos de cocina Ambiano EA-1295 Professional. Ambiano EA-1295 Professional 15 páginas. Induction cooker
También para Ambiano EA-1295 Professional: Manual de inicio rápido (4 páginas)
Imprimir página
Troubleshooting
During operation, if any problems or errors occur, please check the following table
before calling for service. Below are common errors and the checks to perform.
Problem
The On/Off button
(
) does not respond.
The appliance beeps
continuously and then
stops working.
The cookware does
not heat up to the
required temperature.
The cooking
temperature of the
preset mode is too
high or too low.
Error codes
NOTE: To avoid any danger and damage to the appliance, do not attempt to
disassemble or repair it yourself.
AFTER SALES SUPPORT
AUS
1800 898 750
There is a connection problem. Check if the induction
cooker is connected to the mains and if the plug is
inserted firmly into the wall socket.
You may have put unsuitable cookware on the cooking
plate or you may removed the cookware from the
cooking plate during cooking. Make sure the cookware
is made of steel, iron or aluminum with stainless steel
cladding base and has a base diameter larger than 12cm.
You may have placed the cookware outside of the
cooking zone.
The bottom of the cookware may not be flat. Use
cookware with a flat bottom.
During cooking you can change the power level by
pressing the Increase (+) or Decrease (-) button.
E0 Internal circuit error
E1 Without cookware or Incompatible
cookware used
E2 Internal overheat
E3 Over-voltage
E4 Under-voltage
E5 Top plate sensor open/short circuit
E6 IGBT sensor open circuit/ short circuit
E7 Top plate overheat
Solution
When showing error
codes E1, E2 and
E7, check whether
suitable cookware is
being used.
When showing error
codes E0, E3-E6,
contact the Service
Centre.
MODEL: EA-1295 PRODUCT CODE: 53816 06/2016
11