AMBIC OptiFlow Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Pulverizador de pintura AMBIC OptiFlow. AMBIC OptiFlow 13 páginas.

Imprimir página

Ambic Equipment Ltd - OptiFlow™ Operating Instructions

TROUBLE SHOOTING

FAULT

1. Chemical does NOT fill

dip cup when trigger

pressed (or fills very

slowly)

2. Applicator cup

continues to fill after

trigger released.

3. Chemical running out

of Power Unit.

4. Chemical leaks into

Vacuum Line.

CAUSE

a) Vacuum pump not switched

on.

b) Vacuum line not airtight.

c) Constricted Vacuum Supply

Pipe (G).

d) Chemical Container (D) is

empty.

e) Intake Filter (K) is blocked.

f) Pressure Line (N) is blocked.

g) Inlet to cup assembly (V) is

restricted or block.

h) Pump AOFL/2004-V is faulty.

i) Directional Valve ATS/425 is

faulty.

j) Air in Pressure Line (N).

Debris in applicator valve, or part

is damaged.

a) Loose Connector Nut.

b) Pump Head Manifold.

c) Faulty pump.

Pump faulty.

-9-

REMEDY

a) Switch on vacuum pump.

b) Check that vacuum is

reaching the power unit by

pulling supply pipe out and

testing with finger.

Check vacuum pipe adaptor

is correctly installed.

c) Check for kinks and

overtightened cable ties.

d) Fill container.

e) Clean filter.

f) Clear blockage, check for

constriction or kinks in the

tubing, or for tight cable ties.

g) Check inlet underneath the

top rim and clean using

warm water if chemical

residues are apparent (see

Fig. 5)

h) Check pump and repair or

replace.

i) Check valve and repair or

replace.

j) Vent as described under "2.

Initial start-up".

Ensure that an Intake Filter (K)

is fitted, and that the chemical &

container are free of debris.

a) Locate leak and tighten the

nut.

b) Check the screws are tight.

c) Check the pump and repair

or replace.

Immediately turn off the vacuum

at the tap. Repair or replace the

faulty parts.

OFL7500E v1.2 (03/11/21)