D&K Monarchy Minikote EZ G3 Manual del usuario - Página 13

Navegue en línea o descargue pdf Manual del usuario para Laminadora D&K Monarchy Minikote EZ G3. D&K Monarchy Minikote EZ G3 15 páginas.

Shut the machine off!

Shut the machine off! Minikote EZs have set screws at both ends of each laminating and pull roller. With

the use of a 3/32 hex key, loosen all four set screws on the pull rollers. Cut the plastic between the lami-

nating and pull rollers, grab the loose end and pull. The rollers will rotate freely on the roll shafts and the

"wrap-around" will easily unwrap. Tighten all the set screws and rethread the lm.

Appendix A

Replacing the hand held Cutter Blades.

The hand held cutter blade can be replaced

by removing the small screw on the back of

the cutter, then removing the cutter back.

Caution: The cutter blade is extremely

sharp. Please handle carefully and dis-

pose of properly

pose of properly. Remove and discard the

old blade. Re-install cutter back and screw.

Caution: Do not over tighten screw

Caution: Do not over tighten screw.

Laminator.com