D&R ClubMix Manual - Página 7

Navegue en línea o descargue pdf Manual para Mezclador de música D&R ClubMix. D&R ClubMix 20 páginas.

9.3 START

The start stereo jack connector is for connecting the start functions with external equipment.

If a fader start switch is fitted the tip of the stereo jack socket will short to the ring when the fader is up or the

ON switch is activated or the Cue switch.

10.0 MASTER MODULE

The master module of the ClubMix contains all the electronics for the summing of the left/right signals, the aux

signals, the crossfader signals, the Cue signals, the voice over signals, and the control room monitoring as

well as the power supply. The width of this module is four times the width of the channel module.

10.1 LED BARS

The ledbars are peakreading instruments with attack and release times confirming world standards. The 0dB

led lights when the output reaches +10dBu. This also conforms to studio standards. The peakreading ledbars

are calibrated -6dB down from the output of the console. The ledbars will indicate all levels heard in the

PHONES signal path.

If a different calibration is requested, two small holes below the ledbars allow for adjustment of the ledbar

sensitivity.

10.2 AUX SENDS

The aux. sends are the master controls of the outgoing level to the aux. outputs. Nominal level is +4dBu

ground compensated balanced at 100 ohm output impedance. There are two CUE switches to check the AUX

outputs post fader.

10.3 AUX RETURN

The aux return is a stereo line input for the program mixing amps, the Voice Over does not have any influence

on these because the Aux return is intended to return effects coming from mics from the mono channels that

control the Voice Over circuitry.

All signals are fed to the program mix amp and adjusted in level by the aux return control.

There is a CUE switch to listen pre fader Aux return.

10.4 VOICE OVER SECTION.

The Voice over section controls the level dynamically of the signals coming from the stereo channels.

Any Mic/Line channel where a voice over switch is activated is able to lower the program level (which are the

stereo signals coming from the stereo modules directly or through the crossfader section), in a controlled way.

This feature is used when announcing needs to be done without having to control all sorts of levels at the

same time. It also gives a very compact way of combining music with speech.

The amount of attenuation of the music signal can be controlled by the ATT control.

( A maximum of 20dB is possible).

The voice over switch activated the circuit when needed. The REL control below the ATT control controls how

fast the music returns to its original level after the control voltage from the mic/line modules has stopped. In

large buildings with back ground music and regularly announcements it is wise to set the REL(ease) control

halfway or even further to avoid having music between each word or line spoken.

Clubmix manual page 7