Asko WM25 Manual de servicio - Página 13
Navegue en línea o descargue pdf Manual de servicio para Lavadora Asko WM25. Asko WM25 20 páginas.
También para Asko WM25: Manual de servicio (16 páginas), Manual de servicio (16 páginas)
Imprimir página
Components and measurement values
Item number
Component
80 655 63
Motor 50 Hz
80 658 33
CIM-motor
80 637 33
Motor 60 Hz
80 617 06
Heating Element
2000 W
80 761 02
Thermistor
88 012 63.
Drain pump 50 Hz
88 012 64.
Drain pump 60 Hz
80 782 21
Level Switch
Measurement value
Resistances:
Pins 2-3 stator 1.41 Ω
Pins 1-3 stator 0.57 Ω
Pins 4-5 rotor 1.54 Ω
(measured diagonally
across the collector)
Pins 6-7 tacho 135 Ω
Resistances :
Pins 1-3 stator 3,7 Ω
Pins 1-2 stator 3,6 Ω
Pins 2-3 rotor 3,6 Ω
Pins 4-5 tacho 178 Ω
Resistances:
Pins 2-3 stator 1.05 Ω
Pins 1-3 stator 0.58 Ω
Pin 4-5 rotor 1.75
Ω ( Pins diagonally
across the collector)
Pins 6-7 tacho 135 Ω
28.4 Ω
6.1-3.8 k
Ω (at room tempera-
ture 20 – 30°C)
144 Ω.
76 Ω
Comments
All resistance values have tolerances
of ±8 %.
All resistance values have tolerances
of ±8 %.
The thermistor for temperature reading
is located between the motor cradle
and the container. The thermistor mea-
sures and controls the water tempera-
ture that can vary from 0 to 90°C. The
element is disconnected if the thermis-
tor is short-circuited or disconnected
from the programme control card.
The drain pump is combined with an
integrated fine filter trap, which can be
cleaned by the user. If the drain pump
has run for 180 seconds during drain-
ing, the programme stops, resets and a
trouble code is indicated in the display
(on machines without a display, the
LEDs flash).
See above.
Electro mechanical level switch with
two levels, see wiring diagram. Indica-
tes levels for door opening, heat and
overfilling.
Service manual WM25
13