ACR Electronics RCL-600A - SCHEMA REV A Manual de soporte del producto - Página 7

Navegue en línea o descargue pdf Manual de soporte del producto para Luz de inundación ACR Electronics RCL-600A - SCHEMA REV A. ACR Electronics RCL-600A - SCHEMA REV A 12 páginas. Remote control searchlight system with joystick remote control panel
También para ACR Electronics RCL-600A - SCHEMA REV A: Plantilla de montaje (1 páginas), Manual de soporte del producto (12 páginas), Manual de soporte del producto (12 páginas)

Imprimir página
3.3
Wiring of remote control panel
The remote control panel is shipped with a 6-foot (1.83-meter) long, 20 AWG cable. The cable will be attached to the
searchlight and should be connected to the corresponding contacts on the remote control panel based on the wire color.
Refer to Figure 3.
Remote Control Panel
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
10
10
11
11
12
12
3.4
Installing the searchlight
The searchlight can be mounted where desired, using 3/8" length stainless steel fasteners. Keep navigational aids,
antennas, etc., out of the beam path of the light. It is recommended to mount antennas 10 feet (3.05 meters) above the
light, at a minimum. Be sure the 4 nylon shoulder washers, supplied with the searchlight, have been inserted in the
searchlight base mounting holes to prevent a galvanic reaction between the mounting hardware and the base of the
searchlight. Also make sure that the mounting base gasket is securely in place before bolting down. Silicone grease
should be applied to the bottom of the gasket to help in waterproofing the unit.
When mounting, be sure that the unit is able to rotate 360° without hitting any obstructions. Refer to Figure 4 for mounting
details. Mount unit so that the ID label on the mounting base faces forward. This is the home position when light is reset.
See instructions on controls. See Section 4.2 for bulb installation.
CAUTION: The searchlight is not designed for inverted mounting.
CAUTION: Xenon-Arc lights emit electromagnet radiation, which may interfere with some communication or
navigation systems mounted on board.
The preferred location for communication and navigation equipment system antennas is at least 3 meters directly above
the light.
After the light is installed, all critical communication and navigation systems should be checked for proper operation with
the light turned ON and rotated in all directions.
Y1-03-0139F
Source DC 24V ± 10% 8.5A
Control Cable
AWG 20 0.5sq - 15c
Figure 3
Vinyl Cabtyre Cable
600V - VCT - 5.5sq - 2c
+ white
-
black
red
1
2
white
black
3
4
brown
yellow
5

green

6
light green
7
pink
8
light blue
9
orange
10
gray
11
blue
12
Vinyl Cabtyre Cable
300V - VCTF - 0.5sq - 15c
XENON SEARCHLIGHT
PP-307
+
-
1
2
3
4
5
6
7
8
9
10
11
12
CH1
6